Due to the high hardness and wear resistance, electroless nickel-boron (Ni-B) coatings have found numerous applications. In the present study, the influence of the heating rate on the morphological features of oxidized electroless Ni-B coatings was investigated. The oxidation behavior of electroless coating layers was studied with TGA method under non-isothermal conditions at heating rates 5, 9...

Self-heating induced failure of graphene devices synthesized from both chemical vapor deposition (CVD) and epitaxial means is compared using a combination of infrared thermography and Raman imaging. Despite a larger thermal resistance, CVD devices dissipate >3x the amount of power before failure than their epitaxial counterparts. The discrepancy arises due to morphological irregularities implic...

In this paper an extensive verification of the extraction method (published earlier) that consistently accounts for self-heating and Early effect to accurately extract both base and thermal resistance of bipolar junction transistors is presented. The method verification is demonstrated on advanced RF SiGe HBTs were the extracted results for the thermal resistance are compared with those from an...

induction heating is widely used in metal industry for melting or heating thin slabs in a continuous casting plant. the wide application is based on good efficiency, high production rate and non-polluting conditions. for designing a parallel resonant induction heating system, calculating the capacitance for the resonant circuit is important, because its value affects resonance frequency, output...

Self-heating structural materials, being useful for deicing and space heating, are reviewed. They include cement–matrix and polymer–matrix composites that are rendered self-heating through enhancing their effectiveness for resistance heating. The enhancement is attained by the use of electrically conductive fibers (continuous or discontinuous) and interlayers. The interlaminar interface between...

Scratching experiments were carried out on silicon wafers (100) with diamond styli of nominal 2, 5, and 10 μm radius. Relevant parameters varied and investigated were: load (10 to 100 mN) and depth of penetration, material hardness, electrical current effects and measured resistance, and speed effects. Direct electrical heating of the metallic high pressure phase of silicon during scratching ex...

Zero temperature coefficient of resistance (TCR) is essential for the precise control of temperature in heating element and sensor applications. Many studies have focused on developing zero-TCR systems with inorganic compounds; however, very few have dealt with developing zero-TCR systems with polymeric materials. Composite systems with a polymer matrix and a conducting filler show either a neg...

This paper describes a new motion control system for actuators based on antagonistic-pair arrangements of electrically-heated SMA elements. Two different controllers have been tested, both of them incorporating a new rapid heating strategy that greatly increases the rate at which the elements can be heated without risk of overheating. Essentially, the current applied to the element is the lesse...

The relationship of the biasing condition and the self-heating effect of a multi-channel metallic oxide semiconductor field effect transistor (MOSFET) device was examined using various channel currents ranging from triode to saturation regimes. When temperature non-uniformity is generated due to transistor self-heating, the local thermal resistance is conventionally defined through the differen...

Knowledge of bacteria's heat resistance is essential for developing effective thermal treatments. Choosing an appropriate test method is important to accurately determine bacteria's heat resistances. Although being a major factor to influence the thermo-tolerance of bacteria, the heating rate in samples cannot be controlled in water or oil bath methods due to main dependence on sample's thermal...