The friction and wear properties of polyamide 66 (PA66), polyphenylene sulfide (PPS) and polytetrafluoroethylene (PTFE) sliding against hemselves under dry sliding and oil-lubricated conditions were studied by using a pin-on-disc tribometer. The effect of applied load and sliding peed on tribological behaviors of the polymer–polymer sliding combinations under dry sliding and oil-lubricated cond...

Polyvinyl ester green composites were synthesized with walnut shell powder (WSP) by in-situ polymerization technique. The green composites have been evaluated for mechanical properties such as tensile strength, tensile modulus and hardness. Sliding wear loss, specific wear rate and coefficient of friction were investigated by using computerized pin-on–disc machine at normal applied loads of 20,...

Hypereutectic aluminum silicon alloys are mainly used in cast form in important components like pistons, cylinder liners, rocker arms, air conditioner compressors, brake drums, engine blocks, etc. These have inherent advantages of being high wear resistance, high strength to weight ratio, high corrosion resistance, good cast performance, high thermal conductivity, good weldability, etc. The inf...

The presence of oxygen in the environment in which a steel sliding system operates will promote a mild form of wear with wear debris consisting mainly of iron oxides. Of the oxidation-dominated mechanisms, mild-oxidational wear (the prefix describes the extent of oxidation and not the wear rate) has been most extensively investigated. In this paper, examples will be used to show that the wear-m...

In this paper, the gear material 20CrMnTi was selected as the research object. Friction and wear behavior was performed on the M2000 friction and abrasion tester. The friction and wear mechanisms of 20CrMnTi steel were discussed under coupling of rolling and sliding. The results show that damage of steel-steel couples under coupling of rolling and sliding is caused by the interaction of mechani...

We have deposited a series of WC–Co coatings by the high velocity oxy fuel (HVOF) process, using three different powders, and different spray conditions. The powders are a nanocrystalline (Nanocarb), a near-nanostructured powder (Infralloy) containing a proprietary additive aimed at retarding grain growth, and multimodal (mixed micro and nano) powder (Nanomyte). HVOF spray conditions were stoic...

Fundamental understanding of tribochemical wear mechanism of oxide-free single crystalline silicon (without native oxide layer) is essential to optimize the process of ultra-precision surface manufacturing. Here, we report sliding speed-dependent nanowear of oxide-free silicon against SiO2 microspheres in air and in deionized water. When contact pressure is too low to induce Si yield, tribochem...

Friction and wear, often treated as unrelated, distinct phenomena, are manifestations of the same dissipative physical processes occurring at sliding interfaces. Friction force dissipates power and generates entropy. Wear irreversibly changes a material structure, often with loss of material. Associated with both friction and wear is production of irreversible entropy by interfacial dissipative...

objectives: several studies have assessed the characteristics and properties of silorane-based composites and adhesive systems. considering the extensive application of tooth-whitening agents, possible deteriorative effects of tooth bleaching agents on these restorative materials must be studied. the aim of this study was to evaluate the effect of an in-office carbamide peroxide-based tooth ble...

Functionally graded aluminium/zirconia metal matrix composite was fabricated using stir casting technique followed by horizontal centrifugal casting process and a hollow cylindrical functionally graded composite (150 x 150 x 16 mm) was obtained with centrifuging speed of 1200 rpm. The microstructural evaluation and hardness test was carried out on the outer and inner surface of the functionally...