Thin amorphous Ge films on glass substrates are irradiated by single picosecond ~ps! laser pulses and the induced melting and solidification process is followed by means of real-time reflectivity measurements with ps resolution using a setup based on a streak camera. Due to the excellent time resolution achieved in single exposure, the recalescence process occurring upon solidification can be c...

The optimal design of risers for castings has been the subject of numerous investigations and this paper determines the optimal dimensions when Chvorinov’s rule for solidification is obeyed by both the riser and casting and solidification time is the only constraint involved .This problem can be formulated to minimize the riser volume subject to the constraint that the riser solidification time...

Numerous experimental data on the rapid solidification of binary systems exhibit the formation of metastable solid phases with initial (nominal) chemical composition. This fact is explained by complete solute trapping leading to diffusionless (chemically partitionless) solidification at a finite growth velocity of crystals. Special attention is paid to developing a model of rapid solidification...

The solidification of gamma TiAl alloys is of interest to the aerospace and automotive industries. A gamma TiAl multicomponent alloy: Ti–45.5Al–4.7Nb–0.2C–0.2B (at. %) has been the focus of a study to investigate the solidification conditions that led to a Columnar to Equiaxed Transition (CET) in a directional solidification experiment where traditional Bridgman solidification was combined in s...

The present paper aims to investigate the solidification behavior and the forgeability of Aluminum alloy (LM6)-SiCp composites at different section of three-stepped composite castings. The temperature of the cast composites during solidification has measured by putting K-type thermocouples at the center of the each step/section, from which the solidification curves were constructed. The forgeab...

The phenomenon of impingement and solidification of a molten metal droplet on a substrate occurs in processes like thermal spray coating and spray casting. Molten metal droplet after impingement over a substrate becomes a splat after spreading and solidification. The phenomenon of spreading and solidification of a droplet can be understood by mathematical modeling. In the present work, the spre...

The solidification process during squeeze casting is analyzed based on the classical solidification and plastic deformation theory. The linear relationship between punch velocity and the solidification rate is established if the density change of molten meals is neglected. To obtain defect-free castings, the punch velocity should be larger than the solidification rate. The densification mechani...

Effective control of melting and solidification behaviours of materials is significant for numerous applications. It has been a long-standing challenge to increase the melted zone (MZ) depth while shrinking the heat-affected zone (HAZ) size during local melting and solidification of materials. In this paper, nanoparticle-induced unusual melting and solidification behaviours of metals are report...

−− An experimental study on solidification structure development and on endogenous inclusion precipitation in a continuously cast resulphurised steel is presented. Results were obtained by investigating two heats of a free cutting C-Mn steel cast in billets with a diameter of 145 mm. The as cast structure was evaluated by macroand microscopic analyses. Primary and secondary dendrite arm spacing...

In steels the dependence of ambient temperature microstructure and mechanical properties on solidification rate is not well reported. In this work we investigate the microstructure and hardness evolution for a low C low Mn NbTi-microalloyed steel solidified in the cooling rate range of 1-50 Cs-1. The maximum strength was obtained at the intermediate solidification rate of 30 Cs-1. This result h...