polyacrylonitrile (pan) membranes with nano-porous surface and high hydrophilicity were fabricated by addition of polyoxyethylene (40) nonylphenyl ether (igepal) as an additive in the casting solution. the membranes were prepared from pan/igepal/1-methyl-2-pyrrolidone (nmp) via phase inversion induced by immersion precipitation technique. pure water was used as coagulation medium. the effects o...

in this study, a mixed matrix polyethersulfone/iron-nickel oxide nanoparticle nanofiltration membrane was prepared by the solution casting technique. polyvinylpyrrolidone was also used as a membrane pore former in membrane fabrication. the effect of iron-nickel oxide nanoparticles concentration in the casting solution on the membrane structure and performance was investigated. scanning optical ...

In a foundry casting line, contaminants are released from a large area. Casting fumes include both volatile and particulate compounds. The volatile fraction contains hydrocarbons, whereas the particulate fraction mostly comprises a mixture of vaporized metal fumes. Casting fumes lower the air quality in foundries. The design of local ventilation for the casting area is a challenging task, becau...

Asymmetric polyethersulfone (PES) nanofiltration membranes were prepared via phase inversion technique. PES polymer, Brij 58 as surfactant additive, polyvinylpyrrolidone (PVP) as pore former and 1-methyl-2-pyrrolidone (NMP) as solvent were used in preparation of the casting solutions. Distillated water was used as the gelation media. The scanning electron microscopy (SEM) images and measurement...

The solidification heat transfer, melt convection and volume shrinkage in the casting of an energetic material are analyzed through numerical modeling and experimental investigation. The shrinkage resulting from phase change is considered through the volume of fluid method. The model is validated against an analytical solution and then applied to study the volume contraction during the casting ...

The effects of the properties of casting solution on the surface structure of poly(methyl methacrylate) (PMMA) films were systematically investigated. It was observed that the hydrophobicity of PMMA films increased with increasing viscosity of the corresponding polymer solution regardless of the film-formation techniques that were utilized. The ratio of the C-H symmetric stretching vibrations o...

The work presents the results of the studies of Co-Cr-Mo casting alloys used in the production of frame casts of removable dentures, crowns and bridges in dental prosthetics. The studies were performed on four Co-Cr-Mo alloys of different contents of Mo, W and other additives. Electrochemical tests were performed, which aimed at examining the corrosion resistance of the alloys and observing the...

Synopsis Mathematical modeling of stress generation in casting processes is a difficult, complex subject that is now receiving increased attention. This paper reviews the basic equations, solution methods and important phenomena associated with casting processes that require special numerical treatment. Stress modeling begins with a coupled, transient heat transfer analysis, including solidific...

Using equations and boundary conditions derived in Part I*, calculations have been performed on the ternary diffusion processes that occur in acellulose acetate (CA) -acetone casting solution immersed into a water bath. The necessary concentration-dependent thermodynamic and hydrodynamic parameters have been derived from experimental data on the three limiting binary mixtures. Calculations show...

Large-scale alignment of lamellae in thin films of diblock copolymers containing polyacrylonitrile and poly(n-butyl acrylate) was achieved by casting copolymer solution on a silicon substrate moved away at a constant speed from the casting nozzle (zone-casting). Grazing incidence small-angle X-ray scattering revealed that the lamellae, which were perpendicular to the substrate, were also aligne...