[1] Steam explosions, or littoral blasts, generated when pyroclastic flows interact with seawater may be a common, although rarely documented, phenomena. The development of steam explosions rather than passive steam production is related to the rate of thermal energy transfer from hot pyroclasts to water. We conduct a series of laboratory experiments to quantify the heat transfer and steam prod...

In power station practice, work is extracted from expanding steam in three stages namely High Pressure(HP), Intermediate Pressure(IP) and Low Pressure(LP) turbines. During the expansion process in the LP turbine, the steam cools down and at some stages, it nucleates to become a two-phase mixture. It is well-acknowledged in the literature that the nucleating and wet stages in steam turbines are ...

Steam-water flow exists in most geothermal reservoirs where steam-water capillary pressure plays an important role in controlling fluid distribution, transfer of liquid between fracture and matrix, well productivity, and even the reserves. However, it is very difficult to measure steam-water capillary pressure due to the phase transformation and the significant mass transfer between the two pha...

teurizers (1). I f these various precautions are not sufficient to produce a satisfactory steam supply, the alternative is the production of culinary steam from potable water, using the unsatisfactory primary steam supply as a source of heat. The 3A recommended practice just referred to includes a sketch of the recommended location of the parts necessary for such an installation. The other alte...

In this paper, Steam Assisted Gravity Drainage (SAGD) is introduced and its advantages over ordinary steam injection is demonstrated. A simple simulation model is built and three scenarios of natural production, ordinary steam injection, and SAGD are compared in terms of their cumulative oil production and cumulative oil steam ratio. The results show that SAGD can significantly enhance oil prod...

The dangers posed by non-condensable gases (NCGs) in steam sterilisation processes have long been underestimated. Biological indicators, or the best chemical indicators on the market, do not signal the presence of a NCG content of up to 10% in a sterilisation process so long as there is mixing of steam and NCGs in the sterilisation chamber. Already back in 1963, Bowie and Dick (1) demonstrated ...

Steam is a key energy vector for industrial sites, most commonly used for process heating and cooling, cogeneration of heat and mechanical power as a motive fluid or for stripping. Steam networks are used to carry steam from producers to consumers and between pressure levels through letdowns and steam turbines. The steam producers (boilers, heat and power cogeneration units, heat exchangers, ch...

DC lOO%-steam plasma characteristics were investigated for the application of halogenated hydrocarbon decomposition because steam plasmas are chemically reactive. However, plasma system generally requires complex subsystems such as steam generators and cooling units. The presented steam plasma system is a portable light-weight plasma generation system that does not require any gas supply unit. ...

There exists general agreement that the steam engine's rise in importance occurred at the same time as large increases in firm size and growing urbanization, but no consensus concerning the degree to which the steam engine served as an exogenous fo rce fueling urban growth. We reexamine the hypothesis that a leading brand of steam engine made by the Corliss Company fue led urbanization in the l...

Superheated steam drying technique has been known for a long time, but its application to food drying has received little attention. In this work, superheated steam was applied to dry fresh parsley (Petroselinum Cripsum). A mathematical model to simulate this drying process was developed by using mass and energy conservation equations for solid and steam phases. The resulting partial differenti...