Dynamic recrystallization (DRX) processes are widely used in industrial hot working operations, not only to keep the forming forces low but also to control the microstructure and final properties of the workpiece. According to the second derivative criterion (SDC) by Poliak and Jonas, the onset of DRX can be detected from an inflection point in the strain-hardening rate as a function of flow st...

The uniaxial compressive responses of silicone rubber (B452 and Sil8800) and pig skin have been measured over a wide range of strain rates (0.004–4000 s ). The uniaxial tensile response of the silicone rubbers was also measured at low strain rates. The high strain rate compression tests were performed using a split-Hopkinson pressure bar made from AZM magnesium alloy. High gain semi-conductor s...

In this paper, results of an investigation on the strain hardening responses of superalloy MP35N with two average grain sizes of 38 and 1 μm, during room temperature tensile testing are reported. The microstructural evolution of the deformed samples was studied using optical and transmission electron microscopy (TEM) techniques. The strain hardening behavior of the 38 μm material was rather sim...

The quantitative characterization of the microstructure evolution in high-Mn steel during deformation is of great importance to understanding its strain-hardening behavior. In the current study, in situ high-energy synchrotron X-ray diffraction was employed to characterize the microstructure evolution in a Fe-17Mn-1.5Al-0.3C steel during a tensile test. The microstructure at different engineeri...

This paper presents a summary of the new semi-analytical integration method presented in [10] for von Mises elastoplasticity model with combined linear isotropic-kinematic hardening within a small deformation range. Solutions for the case of constant strain rate and constant stress rate assumptions are also presented. Furthemore, it is shown how the general solution reduces to the particular ca...

The digital image correlation (DIC) technique was utilized in conjunction with mechanical experiments carried out at different strain rates to study the negative strain rate sensitivity (NSRS) in face-centered cubic (fcc) Hadfield steels. The results shed light onto the variation of local strain fields and serrations in the stress– strain curves of Hadfield steels as a function of strain rate w...

Stress–strain response under constant and variable strain-rate is studied for selected models of inelastic behavior. The derived closed-form solutions for uniaxial loading enable simple evaluation of the strain-rate effects on the material response. The effect of an abrupt change of strain-rate is also examined. Non-Newtonian viscosity which decreases with an increasing strain-rate is incorpora...

Indentation is a new method for estimating residual stress. The plastic behavior of the materials under study can affect indentation parameters and, thus, influences the results of residual stress measurement. In this paper, the effect of yield stress and work-hardening exponent on the accuracy of residual stress measurements in steels and aluminums was studied. Results showed that, for m...

The mechanical behavior of a single phase (fcc) Al0.3CoCrFeNi high-entropy alloy (HEA) was studied in the low and high strain-rate regimes. The combination of multiple strengthening mechanisms such as solid solution hardening, forest dislocation hardening, as well as mechanical twinning leads to a high work hardening rate, which is significantly larger than that for Al and is retained in the dy...