Results of high-order direct numerical simulations are summarized for the evolution of crossflow disturbances in incompressible wing-generic boundary-layers with suction at the wall. The concept of smart suction, an adapted combination of the upstream-flow-deformation (UFD) technique and suction, is presented for laminar flow control. In the UFD technique, relatively tightly spaced, useful cros...

INTRODUCTION We compared the efficacy of Karl Storz CMAC Tip™ with inline suction to CMAC with traditional suction device in cadaveric models simulating difficult airways, using media mimicking pulmonary edema and vomit. METHODS This was a prospective, cohort study in which we invited emergency medicine faculty and residents to participate. Each participant intubated 2 cadavers (one with simu...

BACKGROUND Three kinds of conditions should be considered to reduce free hemoglobin production using an autologous cell salvage device. They are the negative suction pressure, the size of suction tip, and the air contact during suction. We want to examine which condition is the most important factor to produce free hemoglobin. METHODS One pack of red blood cell and one pack of fresh frozen pl...

Leaking in water pipe is a critical issue in Middle Eastern countries such as Kuwait where water is scarce. In-pipe robots can be dispatched to discover the network and inspect the inner surface of the pipe. This thesis describes the design and characterization of suction pads for in-pipe robots. The suction cups are made of hyperelastic materials that contain air channels inside. Instead of us...

PURPOSE To evaluate refractive outcomes of two management approaches after suction loss during the small-incision lenticule extraction (SMILE) technique. PATIENTS AND METHODS This retrospective and comparative study was conducted at the El-Gowhara Private Eye Center. It included 26 consecutive eyes of patients who experienced suction loss during the SMILE technique. Patients were divided into...

Laminar-turbulent breakdown in a swept-wing boundary layer is typically caused by secondary instabilities of steady crossflow vortices (CFVs). So far, boundary-layer suction for laminar flow control in three-dimensional boundary layers has been applied to reduce the crossflow and thus the growth of the primary vortices only. We investigate the influence of strong, localized suction (pinpoint su...

The e!ect of air viscosity on suction force of vacuum pumps for holding micro-components was investigated. The experimental data show that suction force micro-components is much larger than the calculated results without considering in#uence of the lower pressure between the suction plate and the micro-component. According to the dimensional analysis, a theoretical formula of suction force was ...