In this paper a two-phase supply modulator suitable for envelope tracking power amplifier is presented. The designed supply modulator has the linear assisted switching architecture. Two-phase architecture is used in order to reduce the output switching ripples. The proposed architecture uses hysteretic control instead of pulse width modulation (PWM) which significantly reduces the circuit compl...

In today's world of ever-increasing low-power portable electronics, from implants to wireless accessories, powering these devices efficiently and conveniently is an escalating issue. The proposed solution is to wirelessly recharge these lower-power portable devices through a common magnetic link with a higher-power portable device, such as a smartphone. Such a method is convenient for users, en...

A high-efficiency class-E power amplifier is proposed for digital PWM microwave signal amplification in the improved Kahn Technique transceiver. The benefit of using a class-E power amplifier in this design approach is to improve efficiency of the power amplifier due to its switching mode operation, theoretically 100 % with ideal conditions. In this paper a class-E amplifier is designed for the...

13 watt Current Mode Class-D (CMCD) with 60% efficiency is presented. This amplifier is the highest power switch mode microwave power amplifier reported to date. The CMCD architecture is an improvement over the Voltage Mode Class-D in that the parasitic reactance in the active device can be absorbed into the tank circuit resulting in a zero voltage switching condition.

a digital look-up table adaptive predistortion technique using a six-port receiver for power amplifier linearization is presented. the system is designed in ka-band for a dvb-s2 satellite link. we use a six-port receiver at the linearizationloop in place of classic heterodyne receivers. the six-port receiver is implemented by the use of passive microwavecircuits and detector diodes. this approa...

The Class-E power amplifier is widely used due to its high efficiency, resulting from switching at zero voltage and zero slope of the switch voltage. In this paper, we extend general analytical solutions for the Class-E power amplifier to the ideal single-ended Variable-Voltage Class-E (Class-Evv) power amplifier that switches at zero slope but not necessarily at zero voltage. The theory is ver...

The paper presents a combined power amplifier system consisting of a linear amplifier unit with a switched-mode (class D) current dumping stage arranged in parallel. With this topology the fundamental drawback of conventional linear power amplifiers the high loss is avoided. Compared to a pure class D (switching) amplifier the presented system needs no output filter to reduce the switching freq...

i ABSTRACT Nowadays transducers are ubiquitous as interfaces between the increasingly digital world and the real physical world. The same holds for the power amplifiers driving them. This thesis focuses on the design and optimization of high-voltage class-D amplifiers, which are used for driving capacitive piezoelectric actuator loads in active vibration/noise control applications. The main obj...

The class-E amplifier [1]-[11] is remarked as the next candidate of digital wireless power transmitters. Non-switching power amplifiers suffer from low power-conversion efficiency due to their inherent power loss in high back off area. Hence, switching power amplifiers such as class-D and E are remarked as a remedy for improving power-conversion efficiency and prolonging battery lifetime of por...

A new symmetrical topology switching power amplifier is introduced for professional audio use. The amplifier is composed by a pair of semi soft switched half-bridges with independent feedback control. Whole overall layout looks very similar than an already bridge configured stereo amplifier with few exceptions. Although the complexity of the proposed topology is at least twice of the convention...