the present work is an experimental study of steady state convective heat transfer of de-ionized water with a (0.04% by volume) volume fraction of al2o3 nanoparticles dispersed to form a nanofluid that flows through an aluminium tube.laminar fully developed flow heat transfer coefficient of al2o3 nanoparticles are dispersed in water in circular tube is discussed in this paper. in order to valid...

Spark plasma sintering (SPS) is currently widely applied to existing alloys as a means of further enhancing the alloys' figure of merit. However, the determination of the optimal sintering condition is challenging in the SPS process. This report demonstrates a systematic way to independently optimize the Seebeck coefficient S and the ratio of electrical to thermal conductivity (σ/κ) and thus ac...

The thermal conductivity of boron nitride/ethylene glycol (BN/EG) nanofluids was investigated by transient hot-wire method and two abnormal phenomena was reported. One is the abnormal higher thermal conductivity enhancement for BN/EG nanofluids at very low-volume fraction of particles, and the other is the thermal conductivity enhancement of BN/EG nanofluids synthesized with large BN nanopartic...

Common heat transfer fluids such as water, ethylene glycol, and engine oil have limited heat transfer capabilities due to their low heat transfer properties. Nanofluids are suspensions of nanoparticles in base fluids, a new challenge for thermal sciences provided by nanotechnology. In this study, we are to optimize and report the effects of various parameters such as the ratio of the thermal co...

Due to the numerous applications of nanofluids, investigating and understanding of thermophysical properties of nanofluids has currently become one of the core issues. Although numerous theoretical and numerical models have been developed by previous researchers to understand the mechanism of enhanced heat transfer in nanofluids; to the best of our knowledge these models were limited to the stu...

A critical synthesis of the variants within the thermophysical properties of nanofluids is presented in this work. The experimental results for the effective thermal conductivity and viscosity reported by several authors are in disagreement. Theoretical and experimental studies are essential to clarify the discrepancies in the results and in proper understanding of heat transfer enhancement cha...

Very large thermal conductivity enhancement had been reported earlier in colloidal suspensions of solid nanoparticles (i.e., nanofluids) and more recently also in oil-in-water emulsions. In this study, nanoemulsions of alcohol and polyalphaolefin (PAO) are spontaneously generated by self-assembly, and their thermal conductivity and viscosity are investigated experimentally. Alcohol and PAO have...

In the present work, we report measurements of the effective thermal conductivity of dispersions of single-walled carbon nanotube (SWNT) suspensions in ethylene glycol. The SWNTs were synthesized using the alcohol catalytic chemical vapour deposition method. Resonant Raman spectroscopy was employed to estimate the diameter distribution of the SWNTs based on the frequencies of the radial breathi...

Liquid desiccants such as glycols are used in dehydration process, among which Triethylene Glycol (TEG) is considered as a common choice. The addition of nanoparticles to TEG as the base fluid is one of the prevalent method to improve thermal properties of TEG. In this study, an experimental investigation was performed on thermal conductivity of TEG-based nanofluids with 20 and 40 nm diameter c...

A suspension of particles below 100 nm in size, usually termed as nanofluid, often shows a notable enhancement in thermal conductivity, when measured by the transient hot-wire method. In contrast, when the conductivity of the same nanofluid is measured by the laser flash method, the enhancement reported is about one order of magnitude lower. This difference has been quantitatively resolved for ...