This paper reports the preliminary results of a newly developed method for measuring dynamic modulus of thermoplastic materials at a given ultrasonic frequency. In the method, a material specimen is squeezed at the tip of the horn of a conventional ultrasonic welding machine. The mechanical impedance of the material specimen under loading is then deduced by processing the input electrical imped...

Ultrasonic metal welding has been used widely to join battery cell terminals, or tabs (either Al or Cu), with bus bars (Cu) to form assembled battery packs in battery electric vehicles. However, the mechanism of ultrasonic welding for Al/Cu is still not well understood. In this work, the microstructures of the ultrasonic welds between three layers of lithium-ion battery tabs (either Al or Cu) a...

Ultrasonic-assisted tungsten inert gas welding was carried out on a thin plate of 2195 Al-Li alloy, and the characteristics of the weld pores were analyzed in terms of their size and porosity. The effects of welding speed and ultrasonic power on the porosity and size of the pores were investigated. The pores were found to occur primarily adjacent to the surface of the weld. The porosity decreas...

The effects of welding energy on the mechanical and microstructural characteristics of ultrasonic-welded pure copper plates were investigated. Complex dynamic recrystallization and grain growth occurred inside the weld zone during ultrasonic welding. At a low welding energy, a thin band of straight weld interfaces was observed and had an ultra-fine grain structure. With an increase in welding e...

Ultrasonic welding is a rapid, promising bonding method for the bonding of polymer chips; yet its use is still limited. We present two lab-on-a-chip applications where ultrasonic welding can be preferably applied: (1) self-aligned gapless bonding of a two-part chip with a tolerance of 50 μm; (2) bonding of a large area shallow chamber (1.8 cm(2) × 150 μm). Using injection moulding combined with...

In ultrasonic metal welding, two metal sheets are joined by the application of high frequency ultrasonic vibrations (20 kHz) under moderate pressure in which the vibrations are applied parallel to the interface between the sheets. The high frequency relative motion between the sheets forms a solid–state weld through progressive shearing and plastic deformation between surface asperities that di...

A method has been developed allowing fabrication of electronic boards from flexible polymer film by ultrasonic embossing and welding within seconds. A commercially available ultrasonic welding machine and micro patterned tools from aluminum are employed first to generate conductor paths on a flexible polymer film, in a further step, surface mounted devices (SMDs) are assembled and fixed on the ...

Heating of workpieces plays an influential role in ultrasonic welding. In the present paper, an attempt was made to further understand the heating mechanism during ultrasonic welding. Three equations in this regard were derived. Firstly, based on the viscoelastic properties of the workpieces, the equation governing heat generation was derived. Secondly, a thermal equivalent circuit model was de...