one of the effective methods to improve the thermal efficiency of solar collectors is using nanofluids as the coolant. the present study experimentally investigated the effect of sio2/water nanofluid with 1% mass fraction on the performance of a symmetric collector, i.e. conical solar collector. the conical solar collector with 1 m2 area and normal to the earth was tested in ahvaz, a city in th...

A two-phase flow experiment using air and water-based γ-Al2O3 nanofluid was conducted to observe the basic hydraulic phenomenon of nanofluids. The local two-phase flow parameters were measured with a conductivity double-sensor two-phase void meter. The void fraction, interfacial velocity, interfacial area concentration, and mean bubble diameter were evaluated, and all of those results using the...

Experimental investigations of heat transfer coefficient of CuO/Water nanofluid are reported in this paper. The heat transfer coefficient of the CuO/water was measured with the help of double pipe heat exchanger. The nanofluid was prepared by dispersing a CuOnano particle in deionized water. CuO/water nanofluid with a nominal diameter of 27nm at different volume concentrations (0.1 &0.3 vol.%) ...

This article reports a recent study on the application of a two-phase closed thermosyphon (TPCT) in a thermosyphon for economizer (TPEC). The TPEC had three sections of equal size; the evaporator, the adiabatic section, and the condenser, of 250 mm × 250 mm × 250 mm (W × L × H). The TPCT was a steel tube of 12.7-mm ID. The filling ratios chosen to study were 30, 50, and 80% with respect to the ...

A numerical investigation has been carried out applying single phase approach on turbulent forced convection flow of water based Al2O3 and TiO2 nanofluids flowing through a horizontal circular pipe under uniform heat flux boundary condition applied to the wall. The effect of volume concentrations, Brownian motion and size diameter of nanoparticles on flow and heat transfer have been examined fo...

Convective heat transfer can be enhanced by changing flow geometry and/or by enhancing thermal conductivity of the fluid. This study proposes simultaneous passive heat transfer enhancement by combining the geometry effect utilizing nanofluids inflow in coils. The two nanofluid suspensions examined in this study are: water-Al2O3 and water-CuO. The flow behavior and heat transfer performance of t...

A heat exchanger using nanofluid needs to operate at optimum mass concentration level to get the maximum heat transfer performance. A numerical analysis is performed on the heat transfer and pressure drop of water-based γ-Al2O3 nanofluid gasketed-plate heat exchanger to specify its optimum conditions. Cold water will be heated by γ-Al2O3/water nanofluid. The results showed that optimal volume c...

in this paper, overall heat transfer coefficient and friction factor of water based γ-al2o3 nanofluid in a double tube counter flow heat exchanger have been measured experimentally under turbulent flow condition. for better dispersion of γ-al2o3 nanoparticles in distilled water, magnetic stirrer and ultrasonic vibrator (with a power of 240 kw and frequency of 35 khz) were implemented. the stabi...

This study compares environmental and economic impacts of using nanofluids to enhance solar collector efficiency as compared to conventional solar collectors for domestic hotwater systems. Results show that for the current cost of nanoparticles the nanofluid based solar collector has a slightly longer payback period but at the end of its useful life has the same economic savings as a convention...

Natural heat convection of water-based alumina (Al2O3/water) nanofluids (with volume fraction 1% and 4%) in a horizontal cylinder is numerically investigated. The whole three-dimensional computational fluid dynamics (CFD) procedure is performed in a completely open-source way. Blender, enGrid, OpenFOAM and ParaView are employed for geometry creation, mesh generation, case simulation and post pr...