For many years, the asphalt industry has been aware of the energy savings and environmental benefits inherent in cold mix or warm mix asphalt technologies. Environmental awareness and the need for improved energy efficiency has increased rapidly over the past few years and extensive measures such as the air pollution reduction targets set by the European Union under the Kyoto Protocol have enco...

Asphalt has been modified for the past several decades using various additives, including synthetic polymers. Polymer modification improves structural and engineering characteristics of the binder, which is a result of improvement in rheological characteristics of binder as well as its adhesion capability with the aggregate. Such enhancement inevitably enhances the performance characteristics o...

The quality of hot mix asphalt is affected by the quality and consistency of input aggregates and the control of the production process. To improve the quality of hot mix asphalt, both the aggregates gradation and the process variables must be considered. Current practice involves taking samples from actual production and analyzing them in the lab. The entire process can take two hours, which, ...

Running is performed on different natural surfaces (outdoor) and artificial surfaces (indoor). Different surface characteristics cause modification of the lower leg muscle activation pattern to adopt ankle stiffness to these characteristics. So the purpose of our investigation was to study changes of lower leg muscles activation pattern in running on different natural running surfaces. Six male...

A car-borne survey was carried out in the northwestern, or Tokatsu, area of Chiba Prefecture, Japan, to make a detailed distribution map of absorbed dose rate in air four years after the Fukushima Daiichi Nuclear Power Plant accident. This area was chosen because it was the most heavily radionuclide contaminated part of Chiba Prefecture and it neighbors metropolitan Tokyo. Measurements were per...

The dynamic modulus is the main input material property of asphalt mixtures for the modern mechanistic-empirical asphalt pavement design methods. The dynamic modulus is determined in laboratory by different procedures but in all cases, they require sophisticated equipment and well-trained personnel. When these experimental results are not available, they could be estimated using different predi...

In this study, stiffness modulus parameters of asphalt concrete were determined experimentally for different temperature and exposure times. The stiffness modules were calculated according to Nijboer stiffness module. Basic physical properties and the quantity of bitumen of asphalt core samples were designated for determining the stiffness modules. The samples were exposed to 17 C (reference te...

This report summarizes a detailed report presenting the first and second year of field and laboratory measurements and statistical analyses and performance estimates for tire/pavement noise, permeability, ride quality, distress development, and friction properties of four types of asphalt pavement surface types used by the California Department of Transportation: open-graded asphalt concrete (O...

The classical asphalt mix manufacturing commonly requires the heating and the complete drying of aggregates. The induced energy cost has opened the way to develop alternatives processes with low energy/ carbon materials such as Warm Mix Asphalt (WMA). Their manufacturing requires specifics techniques to achieve similar performances than Hot Mix Asphalt (HMA). However, manufacturing temperature ...

This paper reports the facile preparation, mechanical performance and linear viscoelasticity of polyetheramine-cured rubber-like epoxy asphalt composites (EACs) with different asphalt contents. Compared with previous EACs prepared via complex chemical reactions and time-consuming high-temperature curing, the EACs reported here were obtained by using a compatible, bi-functional polyetheramine an...