The present investigation characterizes tannery effluents by determining water quality parameters and some selected trace metallic constituents in order to measure the magnitude of environmental pollution. Effluents and sediments have also been used to isolate chromium-resistant bacteria, collected from Hazaribagh area, Dhaka, claimed to be increasing Cr (VI)-enriched environments, and utilized...

Nanoscale iron particles decorated graphene sheets synthesized via sodium borohydride reduction of graphene oxide, showed enhanced magnetic property, surface area and Cr(vi) adsorption capacity compared to bare iron nanoparticles.

Chromium (Cr) is an important raw material in some chemical industries including paint, pigments, textiles, leather tanning, steel fabrication, electroplating, cement preservation, and canning industries. Once in the environment, Cr exists in various oxidation states depending on pH and concentration. Trivalent [Cr(III)] and hexavalent [Cr(VI)] forms are the most common with Cr(VI) being the mo...

The current status and likely future directions of complexes of V(V/IV), Cr(III), Mo(VI), W(VI), Zn(II), Cu(II), and Mn(III) as potential oral drugs against type 2 diabetes are reviewed. We propose a unified model of extra- and intracellular mechanisms of anti-diabetic efficacies of V(V/IV), Mo(VI), W(VI), and Cr(III), centred on high-oxidation-state oxido/peroxido species that inhibit protein ...

In this study , the Cr(VI) rem oval potential of waste mycelium from the industrial x ylanase-producing strain Aspergillus awamori was evaluated. It was d etermined by FTIR analy sis that a mino groups fro m the major fungal wall con stituents, chitin and chitosan, pl ayed a key role in t he metal bindi ng process. The effect of pH, initial ion c oncentration, temperature and amount of biomass ...

Currently, the growth of tannery industries causes a significant volume waste disposal to environment due harmful Cr(VI). Long-time exposure Cr(VI) imposes serious hazards on all living organisms. Hence, treatment remove is not choice but mandatory. Therefore, this study focused removal from aqueous solutions via teff (Eragrostis tef) straw based-activated carbon (TSAC) which was derived locall...

Sawdust is obtained from naturally and easily available which is biodegradable. The bio sorption capacity of the sawdust for hexavalent chromium was studied at different solution pH values (1.5-6), initial metal concentration (50450 mg/L), adsorbent dose (1-7 g/L). The maximum adsorption of Cr (VI) is obtained at pH 1.5, initial concentration 50 ppm and adsorbent dose 5 g/l. The adsorption of c...

EXTENDED ABSTRACT Hexavalent chromium [Cr(VI)] has long been recognized as a potential carcinogen, via the inhalation route while nowadays, there is an increasing concern that Cr(VI) is also carcinogenic by the oral route of exposure. According to this, governments apply more stringent regulations for chromium species. There are several discussions and intentions to lower the current maximum pe...

Nanofiltration and reverse osmosis are investigated as a possible alternative to the conventional methods of Cr(VI) removal from model water and industrial effluent. The influences of feed concentration, water recovery, pH, and the coexisting anions were studied. The results have shown that retention rates of hexavalent chromium can reach 99.7% using nanofiltration membrane (NF-HL) and vary fro...

Physical adsorption and photocatalytic reduction of Cr(VI) in magnetic separable beads were investigated. In order to elucidate the kinetics of photocatalytic process, operating parameters such as catalyst dosage and the initial concentration were examined in detail. It was observed that the reduction rate of Cr(VI) increased with an increase in the catalyst loading, as this translated into an ...