In this paper, the brake driving intention identification parameters based on the fuzzy controlare summarized and analyzed, the necessary parameters based on the fuzzy control of the brake driving intention recognition are found out, and I pointed out the commonly corrupt parameters, and through the relevant parameters ,I establish the corresponding driving intention model.

A cost effective, low maintenance generator brake is proposed using recent developments in thick film, metal oxide resistors. The brake has very low resistance, and virtually no inductance, allowing its use &ring a fault to slow a generator’s acceleration. Simulation results using the 39 Bus New England system show that placing brakes at each machine dramatically increases the global stability ...

In this paper, we consider the minimal period estimates for brake orbits of nonlinear symmetric Hamiltonian systems. We prove that if the Hamiltonian function H ∈ C(R,R) is super-quadratic and convex, for every number τ > 0, there exists at least one τ -periodic brake orbit (τ, x) with minimal period τ or τ/2 provided H(Nx) = H(x). §

The thermal balance analysis is a useful method to determine energy distribution and efficiency of internal combustion (IC) engines. In engines cooling concepts, estimation of heat transfer to brake power ratio, as one of the most significant performance characteristics, is highly demanded. In this paper, investigation of energy balance and derivation of specific heat rejection is carried out e...

AbstractStringent emission norms and environment degradation due to pollutants from the automotive vehicles lead us to find the suitable alternative for the petro-diesel. The oxygenated fuel used is dibutyl ether(DBE). While injection pressure is 200 bar and injection timing is 20.5 0 BTDC we get higher brake thermal efficiency and lower brake specific fuel consumption for DBE10 compare to diesel.

The brakes must be strong enough to stop the vehicle within a minimum distance in an emergency. The driver must have proper control over the vehicle during emergency braking and vehicle must not skid. The brakes must have good antedate characteristics their effectiveness should not decrease with prolonged application and thus it demand that the cooling of the brakes should be very efficient. Fo...

Driven by the desire for safety and automobile regulations, there has been a movement from the drum brake system, where braking force is not as predictable, to the disc brake system that still continues to this day. This shift is perhaps most noticeable in the heavy vehicle industry. However, despite the improvements in stopping distance, the open nature of the disc brake system makes it more p...

Just, Fabian M.S.E.C.E., Purdue University, December 2013. A Strategy for Minimizing Parkinsonian Noise from a Joystick Controlled Wheeled Mobile Robot . Major Professor: Raymond A. DeCarlo. This thesis investigates movement of an electric wheelchair as a wheeled mobile robot (WMR) with a battery rechargeable through regenerative braking.The WMR has two wheels, each of which can propel or brake...

Worldwide, both brake lamps and tail lamps on motor vehicles are required to be red. Previous studies have not examined the effect of this confound in a complex, high-traffic scenario in a driving simulator or on visuomotor behavior. In the first experiment, drivers detected brake lamps on nine lead vehicles and lane changes on two rear vehicles in a 15 min simulated night time highway drive. A...

Objective: To reanalyse data on the lung content of asbestos fibres among brake mechanics. Methods: I re-analysed data published by Butnor, Roggli and colleagues on the lung content of chrysotile and tremolite asbestos fibres among brake mechanics and controls. Statistics of the distributions were estimated by maximum likelihood to accommodate observations below the detection limit. Mean concen...