* Corresponding author. E-mail address: [email protected] (T.E. Gr http://dx.doi.org/10.1016/j.biosystemseng.201 1537-5110/© 2015 IAgrE. Published by Elsevie Energycane is a promising bioenergy crop for warm south-eastern US regions and existing sugarcane machinery is being adapted for energycane cultivation. Because of energycane's comparatively higher fibre content and smaller stem diameters...

In this note we argue that semantic cutting planes refutations are stronger than syntactic ones. In particular, we give a formula for which any refutation in syntactic cutting planes requires exponential length, while there is a polynomial length refutation in semantic cutting planes. This means that syntactic cutting planes does not p-simulate (nor simulate) semantic cutting planes. We also gi...

An image guidance system for computer assisted orthopedic surgery is described. 3D localizers are attached to standard hand-held surgical tools such as osteotomes in order to precisely estimate the position and pose of the tools in real time. 3D localizers are widely used for the navigation of neurosurgery. In orthopedic surgery such as acetabular osteotomy, however, the position and pose infor...

Manufacturing tolerancing is intended to determine the intermediate geometrical and dimensional states of the part during its manufacturing process. These manufacturing dimensions also serve to satisfy not only the functional requirements given in the definition drawing, but also the manufacturing constraints, for example geometrical defects of the machine, vibration and the wear of the cutting...

A judicious choice of insert material, tool geometry and cutting conditions can make hard turning produce better surfaces than grinding. In the present study, an attempt has been made to investigate the effect of cutting tool materials on cutting forces (feed force, thrust force and cutting force) in finish hard turning of AISI D2 cold work tool steel. In conclusion of the results obtained with...

Nanometric cutting involves materials removal and deformation evolution in the surface at nanometer scale. At this length scale, atomistic simulation is a very useful tool to study the cutting process. In this study, large-scale molecular dynamics (MD) simulations with the model size up to 10 millions atoms have been performed to study three-dimensional nanometric cutting of copper. The EAM pot...

Vermicular graphite cast iron, which is widely used in the automotive industry because of outstanding strenght properties. But, there are many problem with regard to machinability of this material. In this study, optimum cutting parameters were studied in order to improve machinability of vermicular graphite cast iron. Experiment parameters which is appropriate for ISO 3685 was selected. Depend...

The development of chip morphology, critical cutting conditions of serrated chip formation and cutting forces were observed and measured by high speed machining experiment for 30CrNi3MoV hardened steel. Results show that the cutting speed and rake angle are leading factors to influence chip morphology and cutting forces. With the increase of cutting speed, the continuous band chip transforms in...