In this paper we will focus on a dual model of engagement in order to globally establish digital fabrication and making in education. We believe that digital fabrication and making in education will not spread and grow roots within the broad educational system without changes in policy on national and international level. We strive to expand the understanding of establishing digital fabrication...

Instrumentation To overcome current difficulty of absolute period control in the EUV multilayer fabrication by sputtering, we have developed an automatic null ellipsometer as a sputtering rate monitor having high enough picometer thickness sensitivity enabling accurate monitoring of the nm period multilayer fabrication [1]. Figure 1 shows schematic drawing of the ellipsometer installed as the s...

Innovations in beef carcass fabrication to improve subprimal yield, retail cut yield, and overall carcass value were evaluated. Alternating sides from 30 beef carcasses were assigned to either an innovative or conventional style of fabrication. The innovative method resulted in greater (P<0.001) total subprimal yield and less (P<0.001) lean trimmings from the forequarter; however, hindquarter t...

Bottom-up self-assembly process used in the fabrication of nanoscale devices yields significantly more defects compared to conventional top-down lithography used in CMOS fabrication. Therefore, applying defect tolerant design schemes is inevitable to be able to map the design to these programmable fabrics around defects. However, defect-aware design mapping could be very time consuming and comp...

Integrated InP polarization converters based on half-ridge structure are studied numerically. We demonstrate that the fabrication tolerance of the half-ridge structure can be extended significantly by introducing a slope at the ridge side and optimizing the thickness of the residual InGaAsP layer. High polarization conversion over 90% is achieved with the broad range of the waveguide width from...

The electrospinning technique is widely used for the fabrication of micro- and nanofibrous structures. Recent studies have focused on the use of less toxic and harmful solvents (benign solvents) for electrospinning, even if those solvents usually require an accurate and longer process of optimization. The aim of the present work is to demonstrate the versatility of the use of benign solvents, l...

In digital X-ray sensors, pixel complexity is limited by the instabilities of amorphous silicon transistors or by the lack of homogeneity of their polycrystalline silicon counterparts. Here, we present a novel approach to the fabrication of thin-film transistors, based on the use of silicon nanowires grown in porous alumina templates. Transistors made from silicon nanowires are essentially stud...

In this paper, we report a new design and fabrication of an integrated two-layer phase mask for five-beam holographic fabrication of three-dimensional photonic crystal templates. The phase mask consists of two layers of orthogonally oriented gratings produced in a polymer. The vertical spatial separation between two layers produces a phase shift among diffractive laser beams, which enables the ...

A method for automated mask-layout and process synthesis for MEMS is presented. The synthesis problem is approached by use of a genetic algorithm. For a given desired device shape, and several fabrication process choices, this synthesis method will produce one or more mask-layouts and associated fabrication process sequences (which when used can generate shapes close to the desired one). Given ...

A novel fabrication method of Si photonic slabs based on the selective formation of porous silicon is reported. Free-standing square lattices of cylindrical air holes embedded in a Si matrix can be achieved by proton beam irradiation followed by electrochemical etching of Si wafers. The photonic band structures of these slabs show several gaps for the two symmetry directions for reflection thro...