Rotary ultrasonic machining (RUM) is a relatively low cost and environmentally benign process for machining of advanced ceramics. Much effort has been made to theoretically and experimentally investigate material removal rate, surface roughness, and tool wear in RUM. However, there is no report on systematic study of edge chipping in RUM drilling of ceramics. This paper presents the results of ...

Abstract: In the present paper, a non-linear numerical study on the 13 century masonry bell tower of the church of San Pietro di Coppito is described. The aim is to have an insight into the causes at the base of the partial collapse suffered by the structure during the L’Aquila earthquake in 2009. To this aim, two different numerical analyses have been performed namely non-linear static (pushov...

The rotor overhang is used to enhance the air-gap flux and improve the power density. Due to the asymmetry in the axial direction caused by the overhang, a time consuming 3D analysis is necessary when designing a motor with overhang. To solve this problem, this paper proposes an equivalent magnetic circuit model (EMCM) which takes account overhang effects without a 3D analysis by using effectiv...

This paper investigates the effect of metallic sheaths on losses and temperature of medium voltage power cables. Two grounding methods of sheaths, including both ends bonding and single point bonding that causes different situations on cable ampacity, are considered. Electrical losses of cables that are main sources of heat are calculated in both conductor and metallic sheath of the cables. She...

In this paper, an analytical formula to calculate the radial stiffness of groove elastic support is presented. The influence of structure parameters on radial stiffness and homogeneity of radial stiffness is investigated as well. The accuracy and calculating speed of the analysis formula are compared to that of finite element method (FEM). Findings are as following: The calculating speed of ana...

Oxyhydrogen is a mixture of Hydrogen (H2) and Oxygen (O2) gases. Detonative mixtures of oxyhydrogens with various combinations of these two gases were used in Gas Detonation Forming (GDF) to form sheets of mild steel. In die forming experiments, three types of conical dies with apex angles of 60, 90 and 120 degrees were used. Pressure of mixtures inside the chamber before detonation was varied ...

Many science and engineering problems can be mathematically modeled as a boundary value problem. Thus, it is very important to build a method to solve for a boundary value problem. For some simple boundary value problems, for example, a two-dimensional Laplace equation, it may be possible to solve it analytically by separation of variables. However, in most applications, boundary value problems...