Background and aims. The aim of this study was to compare flexural strength of specimens processed by conventional and injection-molding techniques. Materials and methods. Conventional pressure-packed PMMA was used for conventional pressure-packed and injection-molded PMMA was used for injection-molding techniques. After processing, 15 specimens were stored in distilled water at room temperatur...

Use of concrete paver blocks is becoming increasingly popular. They are used for paving of approaches, paths and parking areas including their application in pre-engineered buildings and pavements. This paper discusses the results of an experimental study conducted on Fly Ash Concrete with the aim to report its suitability for concrete paver blocks. In this study, the effect of varying proporti...

The aim of this study was to evaluate the effect of reinforcing polyaromatic polyamide (aramid) fibers with various orientations on the flexural properties of denture base resin. Aramid fibers with four orientations of unidirectional, woven, non-woven and paper-type were pre-impregnated and placed at the bottom of a specimen mold. Heat-polymerized denture base resin was packed over the fibers a...

BACKGROUND Microwave postpolymerization has been suggested as a method to improve the flexural strength of an autopolymerizing denture reline resin. However, the effect of microwave postpolymerization on the residual monomer content and its influence on flexural strength have not been investigated. OBJECTIVES This study analyzed the effect of microwave postpolymerization on the residual monom...

Recently, new generations of nanoceramic composite resin CAD/CAM blocks, have been introduced to dentistry, which are claimed to have higher flexural strength, fracture, fatigue and wear resistance, and beside natural looking appearances can be polished easily. Therefore, the aim of this study was to compare flexural strength of 2 nanoceramic composite resin CAD/CAM blocks (Lava Ultimate and Vi...

Micro- and nanocantilevers are increasingly employed as mass sensors. Most studies consider the first flexural mode and adsorbed masses that are either discretely attached or homogeneously distributed along the entire length of the cantilever. We derive general expressions that allow for the determination of the total attached mass with any mass distribution along the cantilever length and all ...

A nanocomposite containing polypropylene (PP) and nano α-Al2O3 particles was prepared using a Haake internal mixer. Mechanical tests, such as tensile and flexural tests, showed that mechanical properties of the composite were enhanced by addition of nano α-Al2O3 particles and dispersant agent to the polymer. Tensile strength was approximately ∼ 16% higher than pure PP by increasing the nano α-A...

Introduction: The Olympus Mons shield volcano on the northwestern edge of Mars’ Tharsis rise is the largest volcano in the solar system. Its volcanic history is intimately tied with the volcanic and geodynamic history of Tharsis and of Mars as a whole. Previous studies used crater counting to estimate the age of the flanks of Olympus, with typical values of ~200 Myr [1]. However, establishing t...

The present study aimed to evaluate the influence of various heat-pressing procedures (different holding time and heat pressing temperature) on the microstructure and flexural strength of lithium disilicate glass ceramic. An experimental lithium silicate glass ceramic (ELDC) was prepared from the SiO2-Li2O-K2O-Al2O3-ZrO2-P2O5 system and heat-pressed following different procedures by varying tem...