In the Lost Foam Casting process, melting point temperature of metal, as well as volume and rate of the foam degradation have significant effect on the mold filling pattern. Therefore, gas generation capacity and gas gap length are two important parameters for modeling of mold filling time of the lost foam casting processes. In this paper, the gas gap length at the liquidfoam interface for a lo...

In vitro experiments have demonstrated that exogenous phospholipid transfer protein (PLTP), i.e. purified PLTP added to macrophage cultures, influences ABCA1-mediated cholesterol efflux from macrophages to HDL. To investigate whether PLTP produced by the macrophages (i.e., endogenous PLTP) is also part of this process, we used peritoneal macrophages derived from PLTP-knockout (KO) and wild-type...

We apply adjoint-based optimization to a Surfactant-Alternating-Gas foam process using a linear foam model introducing gradual changes in gas mobility and a nonlinear foam model giving abrupt changes in gas mobility as function of oil and water saturations and surfactant concentration. For the linear foam model, the objective function is a relatively smooth function of the switching time. For t...

Polyolefins have been widely used in the electrical insulation and cable industry in recent years. One of the main usages of these materials is dielectric insulation in coaxial cables. Low attenuation and high signal transmission speed are among the desired features in coaxial cables. The role of polyethylene foam on signal transmission speed in the coaxial cables is the main focus of this stud...

The mechanical strength of an Al-30% Si alloy in the mushy zone was estimated by using a novel centrifugation apparatus. In the apparatus, the alloy melt was partially solidified, forming a porous structure made of primary Si platelets (Si foam) while cooling. Subsequently, pressure generated by centrifugal force pushed the liquid phase out of the foam. The estimated mechanical strength of the ...

A statistical predictive model is developed that describes the compression properties of phenolic foam reinforced with glass fibers. An analysis of variance is applied to determine the behavior of composite phenolic foam. The material variables used in the study are fiber length, fiber weight fraction and weight percentage of blowing agent. The responses analyzed are density, compressive modulu...

We investigate experimentally the behavior of liquid foams pumped at a given flow rate through a single pore, in the situation where the pore diameter is smaller than the bubble diameter. Results reveal that foam invasion can be observed only within a restricted range of values for the dimensionless flow rate and the foam liquid fraction. Within this foam invasion regime, the liquid content of ...

In this study, a benign process was used to successfully produce low density foam from poly(arylene ether sulfone) (PAES). Both carbon dioxide (CO2) and water as well as nitrogen and water were used as physical blowing agents in a one-step batch process. A large amount of blowing agents (up to 7.5%) was able to diffuse into the PAES resin in a 2-h saturation time. Utilizing water and CO2 as the...

β-Lactoglobulin (BLG) adsorption layers at air-water interfaces were studied in situ with vibrational sum-frequency generation (SFG), tensiometry, surface dilatational rheology and ellipsometry as a function of bulk Ca(2+) concentration. The relation between the interfacial molecular structure of adsorbed BLG and the interactions with the supporting electrolyte is additionally addressed on high...

Cholesterol-loaded macrophage foam cells are a central component of atherosclerotic lesions. ATP binding cassette transporter A1 (ABCA1), the defective molecule in Tangier disease, mediates the efflux of phospholipid and cholesterol from cells to apolipoprotein A-I (apoA-I), reversing foam cell formation. This study investigated the effect of apoA-I on ABCA1 degradation and cholesterol efflux i...