introduction jet stream is strong narrow current concentrated by strong vertical and lateral wind shears (vasantha et al, 2002). according to world meteorological organization nomenclature, jet stream formed when the speed of wind greater than 60 knots or 30 m/s. the major characteristics of the troposphere and lower stratosphere in the vicinity of jet streams were pointed out by a group of met...

The current article considers a method of improvement based on the laws flow motion in developing resource-saving devices analytical analysis research using air ejectors national economy. hydraulic parameters jet lift and ejector are theoretically based, connections obtained tested experimentally. Based experiments, economical inlet water were determined. It was determined that working pressure...

We examine theoretically the spread of a jet impacting on circular disk and hydraulic jump viscoplastic fluid Herschel–Bulkley type. The depth-averaging approach is employed in supercritical region, subcritical flow assumed to be inertialess lubrication treated as shock, where balance mass momentum established radial direction, including effect surface tension across jump. show that, contrast N...

A laboratory investigation of abrasive waterjet cutting wheat straws was conducted. The work aimed at a systematic characterization the capability straws, as potential alternative to discs currently adopted in no-till drills and planters for crop residue management. two level 2IV7?3 fractional factorial design applied investigate influence process parameters on efficiency straws. Straw coverage...

[1] Hydraulic tomography is a cost-effective technique for characterizing the heterogeneity of hydraulic parameters in the subsurface. During hydraulic tomography surveys a large number of hydraulic heads (i.e., aquifer responses) are collected from a series of pumping or injection tests in an aquifer. These responses are then used to interpret the spatial distribution of hydraulic parameters o...

INTRODUCTION: The calculation of Manning n values has been of interest since the Manning equation was presented in the late 1800s (Henderson, 1966). While estimation of n vahm for normal channels has been fairly well standardized, the estimation of n values in areas of dense vegetation continues to be subject to large variations depending on the experience of the engineer and the perceived dens...

using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. in this work two-dimensional incompressible laminar flow of a nanofluid e...

due to the importance of weed control and the limitations of mechanical methods in some places, in this research the water jet cutting for weed control was investigated. the cutting tests were performed on camel thorn weed in shahid bahonar university of kerman. the water jet pressure of 90 bars was achieved with the aid of a suitable pump. the cutting time was studied in a completely randomize...