The present study proposes novel micro-jet impingement heat sink with effusion holes for flow extraction. The design consists of impingement nozzles surrounded by multiple effusion holes to take away the spent fluid. A three-dimensional numerical model is used for steady, incompressible, laminar flow and conjugate heat transfer for the performance analysis of the proposed design. The computatio...

Results of high-order direct numerical simulations are summarized for the evolution of crossflow disturbances in incompressible wing-generic boundary-layers with suction at the wall. The concept of smart suction, an adapted combination of the upstream-flow-deformation (UFD) technique and suction, is presented for laminar flow control. In the UFD technique, relatively tightly spaced, useful cros...

In this study, a self-designed simultaneous crossflow electrocoagulation/electrofiltration (EC/EF) treatment module was evaluated for its overall reatment performance by treating chemical mechanical polishing (CMP) wastewaters including Cu-CMP wastewater and oxide-CMP wastewater. he critical electric field strengths for Cu-CMP and oxide-CMP wastewaters were determined to be 35 and 30 V/cm, resp...

abstract in the present article, effective parameters of the buoyant jets have been evaluated in the stagnant ambient fluid. the jet parameters, geometry parameters and environmental parameters are investigated. using dimensional analysis, a set of dimensionless functions was obtained. to achieve the exact functions, a physical model was built in the hydraulic laboratory of shahid chamran unive...

The development of high-performance thermal systems has increased interest in heat transfer enhancement techniques. The application of additives to heat transfer liquids is one of the noticeable effort to enhance heat transfer. In this paper two-dimensional unsteady incompressible nanofluid flow in a confined jet at the laminar flow regime is numerically investigated. The Mixture model is consi...

In this study, the missile staging process by implementing a side-injected jet is simulated numerically. The problem is considered to be axisymmetric and the thin shear layer approximation of Navier-Stokes equations along with an algebraic turbulence model is used in a quasi-static form for the calculations. The free stream corresponds to a very high altitude flight condition with a Mach number...

in this paper, construction of triplet atmospheric plasma jet using argon, air, oxygen and nitrogen gases is reported. bactericidal effect of the plasma jet is also investigated. to that end, longitudinal geometric configuration for the electrodes was chosen because it would increase the jet length. electrical characteristics, jet length dependencies on the applied voltage and gas flow rate wer...

Dynamic reconfiguration and network programmability are active research areas. State of the art solutions use the Software Defined Networking (SDN) paradigm to provide basic data plane abstractions and programming interfaces for control and management of these abstractions; however, SDN technologies are currently limited to wiredions; however, SDN technologies are currently limited to wired net...