We numerically produce fully amorphous assemblies of frictionless spheres in three dimensions and study the jamming transition these packings undergo at large volume fractions. We specify four protocols yielding a critical value for the jamming volume fraction which is sharply defined in the limit of large system size, but is different for each protocol. Thus, we directly establish the existenc...

We study the effects of fluctuations on the mesoscopic length scale on systems with mesoscopic inhomogeneities. Equations for the correlation function and for the average volume fraction are derived in the self-consistent Gaussian approximation. The equations are further simplified by postulating the expression for the structure factor consistent with scattering experiments for self-assembling ...

In this paper, the initial susceptibility of e-Fe3N magnetic fluid at volume concentrations in the range F = 0.0 ~ 0.0446 are measured. Compared with the experimental initial susceptibility, the Langevin, Weiss and Onsager susceptibility were calculated using the data obtained from the low concentration e-Fe3N magnetic fluid samples. The viscosity of the e-Fe3N magnetic fluid at the same concen...

Dense packings of freely jointed chains of tangent hard spheres are produced by a novel Monte Carlo method. Within statistical uncertainty, chains reach a maximally random jammed (MRJ) state at the same volume fraction as packings of single hard spheres. A structural analysis shows that as the MRJ state is approached (i) the radial distribution function for chains remains distinct from but appr...

In this paper, the initial susceptibility of e-Fe3N magnetic fluid at volume concentrations in the range F = 0.0 ~ 0.0446 are measured. Compared with the experimental initial susceptibility, the Langevin, Weiss and Onsager susceptibility were calculated using the data obtained from the low concentration e-Fe3N magnetic fluid samples. The viscosity of the e-Fe3N magnetic fluid at the same concen...

Utilizing electrical resistance measurements in combination with strain observations on single crystals, it was possible to distinguish the austenite to martensite transformation from the detwinning of the martensite behavior during deformation of NiTiCu shape memory alloys. It was found that the electrical resistance change associated with the detwinning of the martensite variants was as high ...

In this paper, the problem of turbulent forced convection flow of water- alumina nanofluid in a uniformly heated pipe has been thoroughly investigated. In numerical study, single and two-phase models have been used. In single-phase modeling of nanofluid, thermal and flow properties of nanofluid have been considered to be dependent on temperature and volume fraction. Effects of volume fraction a...

A percolation transition in the vortex state of a superconducting 2H-NbSe2 crystal is observed in the regime where vortices form a heterogeneous phase consisting of ordered and disordered domains. The transition is signaled by a sharp increase in critical current that occurs when the volume fraction of disordered domains reaches the value P(c) = 0.26 +/- 0.04. Measurements on different vortex s...

The effect of ferrite grain size on the fatigue and tensile properties of dual phase steels with a 0.25 volume fraction of martensite (Vm) under different heat treatments was investigated. The heat treatments were homogenized at 1200 oC along with several subsequent normalizations at 910 oC, resulting in different microstructures and mechanical properties. After heat treatment, the obtained ste...

Stress-induced martensitic transformations are clarified in classes of NiMnGa alloys which undergo the stress-free, thermal-induced inter-martensite transformation austenite (A) pre-martensite (PM) martensite. This study implements a comprehensive experimental approach, including analysis of the strain–temperature and stress–strain response, which discloses stress-induced inter-martensite trans...