Flow boiling of the perfluorinated dielectric fluid FC-77 in a silicon microchannel heat sink is investigated. The heat sink contains 60 parallel microchannels each of 100 m width and 389 m depth. Twenty-five evenly distributed temperature sensors in the substrate yield local heat transfer coefficients. The pressure drop across the channels is also measured. Experiments are conducted at five ...

An experimental study of boiling heat transfer from a simulated microelectronic component immersed in a stagnant pool of the dielectric Fluorinert (FC-72) is presented. Various enhancement surfaces were attached to an electrically heated copper calorimeter bar having a vertically oriented heat transfer surface area of 12.7x12.7mm. A number of enhancement schemes aimed at a reduction oftheincipi...

The liquid motion induced by surface tension variation, termed the thermocapillary or Marangoni effect, and its contribution to boiling heat transfer has long been a very controversial issue. In the past this convection was not the subject of much attention because, under terrestrial conditions, it is superimposed by the strong buoyancy convection, which makes it difficult to obtain quantitativ...

Quenching of small stainless steel rods in pure water and nanofluids with alumina and diamond nanoparticles at low concentrations (0.1 vol%) was investigated experimentally. The rods were heated to an initial temperature of ~1000 C and then plunged into the test fluid. The results show that the quenching behavior of the nanofluids is nearly identical to that of pure water. However, due to nano...

The effect of flow instabilities on flow boiling heat transfer in microchannels is investigated using water as the working fluid. The experimental test section has six parallel rectangular microchannels with each having a cross sectional area of 1054 × 197 microns. Flow restrictors are introduced at the inlet of each microchannel to stabilize the flow boiling process and avoid the backflow phen...

Phase change through boiling is used in a variety of heat-transfer and chemical reaction applications. The state of the art in nucleate boiling has focused on increasing the density of bubble nucleation using porous structures and microchannels with characteristic sizes of tens of micrometers. Traditionally, it is thought that nanoscale surfaces will not improve boiling heat transfer, since the...

The effect of surface roughness on nucleate boiling heat transfer is not clearly understood. This study is devised to conduct detailed heat transfer and bubble measurements during boiling on a heater surface with controlled roughness. This first of two companion papers discusses details of the fabrication, construction, and operation of the experimental facility. Test pieces are fabricated from...