Effects of insertion of coiled wire in juxtaposition with twisted tapes on heat transfer rate and solar radiation without disturbing the flow inside the riser tubes in a solar flat plate collector is experimentally reconnoitered in this present work. The wire coil used as a turbulator is placed inside the riser tube while the twisted tape is inserted into the wire coil to create a continuous sw...

The organic Rankine cycle (ORC) is an effective technology for power generation from temperatures of up to 400 °C and capacities 10 MWel. use solar irradiation driving ORC a promising renewable energy-based due the high compatibility between operating thermal collector technologies temperature needs cycle. objective this review paper present discuss operation principles solar-ORC wide range sys...

PHOENICS-2010 has been applied to the simulation of heat transfer within a solar panel design on behalf of the LE2M Laboratory of ICAM, Nantes, France. The panel is assumed to be horizontal and consists of three layers; glass, collector and backboard, with air spaces between. The aim of the panel is to warm air through solar irradiation. The glass and collector gather heat by the "greenhouse ef...

Unglazed transpired collectors or UTC (also known as perforated collectors) are a relatively new development in solar collector technology, introduced in the early nineties for ventilation air heating. These collectors are used in several large buildings in Canada, USA and Europe, effecting considerable savings in energy and heating costs. Transpired collectors are a potential replacement for g...

The present work evaluates the performance of solar collector using Al2O3-C2H6O2-H2O nanofluid as a working fluid through both experimental and CFD analysis. Ethylene-glycol water mixture (40:60 v/v) is used as base fluid, where α-Al2O3 nanoparticle of 20 nm average size is dispersed for the preparation of nanofluid of four different volumetric concentration (vol. conc.) of 0.05, 0.075, 0.1 and...

The performance of the Combined Heat and Power Solar (CHAPS) collectors at the Australian National University is described. Results from testing of the collector under steady state conditions at a range of input temperatures are presented. Measured results under typical operating conditions show thermal efficiency around 57% and electrical efficiency around 11%, and therefore a combined efficie...

This study examines modeling and simulation of the transient thermal behavior of a solar collector adsorber tube. The data used for model setup and validation were taken experimentally during the start-up procedure of a solar collector adsorber tube. ANN models are developed based on the nonlinear autoregressive with exogenous input NARX model and are implemented using the MATLAB® tools includi...

Solar thermal water heating systems have been developed to replace conventional heating. Therefore, the design of a parabolic cylinder collector-type solar unit with coil-shaped heater (absorber) has carried out. The cylindrical collector is made an aluminum plate covered reflective sticker and base insulated, having diameter, height, length, position focal point 150, 60, 200, 22.4 cm, respecti...