We report our studies of the linear and nonlinear rheology of aqueous solutions of the surfactant cetyl trimethylammonium tosylate (CTAT) with varying amounts of sodium chloride (NaCl). The CTAT concentration is fixed at 42mM and the salt concentration is varied between 0mM to 120mM. On increasing the salt (NaCl) concentration, we see three distinct regimes in the zero-shear viscosity and the h...

First principles calculations are preformed to systematically investigate the elastic and thermodynamic properties of Re2N at high pressure and high temperature. The Re2N exhibits a clear elastic anisotropy and the elastic constants C11 and C33 vary rapidly in comparison with the variations in C12, C13 and C44 at high pressure. In addition, bulk modulus B, elastic modulus E, and shear modulus G...

The elastic wave transparency phenomenon of a solid sphere coated with metamaterials is investigated in a solid host medium having nonzero shear modulus. The first three scattering coefficients of the coated sphere are derived in the Rayleigh limit and expressed in terms of the effective parameters of the coated sphere assemblage. It is found that the effective bulk modulus, mass density, and s...

strength, flexural modulus, and contraction stress of one orthodontic composite and two flowable composites. Orthodontic brackets were bonded to 45 human maxillary premolars with the composites Transbond XT, Filtek Z-350 flow and Opallis flow and tested for shear bond strength. For measurement of flexural strength and flexural modulus, specimens were fabricated and tested under flexion. For the...

Low shear rate and low frequency measurements focused on the extremely slow dynamics of a three-dimensional body-centered cubic (BCC) structure of an asymmetric block copolymer under nanophase-separated conditions. The material studied was poly(styrene-b-ethylene-co-butylene-b-styrene) swollen in a hydrocarbon oil selective for the midblock. Transient viscosities during start-up of shear flow a...

Investigators have been studying the mechanical phenomena associated with impact to the head for many years. Several theories on the behavior of the brain during head impact have come from these studies but there has been a notable lack of information on the bulk mechanical properties of the brain which are necessary for the evaluation of these theories. This paper represents an initial attempt...

From measurements with a Couette-type viscometer provided with a guard ring it was shown that at the saliva-air interface a protein layer is adsorbed. Measurements of the surface shear modulus of this layer on saliva of 7 healthy subjects were performed at a frequency of about 70 Hz and a temperature of 25 degrees C. For a surface age of about 1.5 h the surface shear modulus and the surface vis...

Rheological characterization of high-solid sludge is a fundamental requirement for optimizing the mixing and transport of high-solid sludge during anaerobic digestion in waste water treatment systems. We investigate the time evolution of physico chemical properties and rheological characteristics of high-solid digested sludge with total solids (TS) 15–20 wt.% during anaerobic digestion. A serie...

Dynamic magnetic resonance elastography (MRE) is a non-invasive method for the quantitative determination of the mechanical properties of soft tissues in vivo. In MRE, shear waves are generated in the tissue and visualized using phase-sensitive MR imaging methods. The resulting two-dimensional (2-D) wave images can reveal in-plane elastic properties when possible geometrical biases of the wave ...

Although, for homogeneous columns, the differences between Engesser’s and Haringx’s formulas for shear buckling have been explained in 1971 by the dependence of shear modulus on the axial stress, for soft-core sandwich columns the choice of the correct formula has baffled engineers for half a century. Recently, Bažant explained this difference by a variational analysis which showed that an agre...