The effects of friction stir processing (FSP) on the microstructure and mechanical properties of aluminum powder metallurgy (PM) parts was investigated. PM parts were then subjected to FSP at advancing speeds (v) of 40-200 mm/min and tool rotational speeds (ω) of 800-1600 rpm. Microhardness (HV) and tensile tests at room temperature were used to evaluate the mechanical properties of the frictio...

mechanical properties of dissimilar weld joints between gost09ch16n4b (a martensitic stainless steel) and aisi 4130 thin sheets made by gas tungsten arc welding (gtaw) were studied using er410nimo and er100s-g filler metals in post weld heat treated conditions. heat treatment cycles consisted of austenitization at 900, 950 and 1000 °c for 1 h and this was followed by oil cooling and tempering a...

The behaviour of the cryogenically treated En52 martensitic valve steel has been experimentally analyzed in this paper. Material samples are subjected to deep cryogenic treatment after completing the regular heat treatment. The critical properties of the valve steel like wear resistance, hardness, tensile strength and impact strength are evaluated for the cryo treated En52 valve steel samples a...

This article reports the effective usage of redmud(RM) an industrial waste ,as a  novel filler in polymer matrix. The composite has been fabricated with redmud as secondary reinforcement in banana fiber reinforced polyester (BFRP) using compression molding technique. The mechanical properties such as tensile, flexural and impact strength have been studied for different fiber weight percentage, ...

in this paper, a new method is proposed for the production of mwcnts/pvc (multi-walled carbon nanotubes/ polyvinyl chloride) nanocomposites. in this method, a spray is used to produce layers of carbon nanotubes within a pvc matrix. various parameters influence the production of the nanocomposite and its mechanical properties. these parameters are studied separately and the effect of each of par...

in this work, a thermoplastic polyurethane elastomer (tpue) model based on polytetramethylene glycol, toluene diisocyanate and 1,4-butanediol was selected and synthesized. according to this model two types of polyurethane nanocomposites were prepared by in situ polymerization and melt intercalation procedures. the organo-modified nanoclay was used in nanocomposites samples in 0.4 weight percent...

We explore BiFeO3 under tensile strain using first-principles calculations. We find that the actual structures are more complex than what had been previously thought, and that there is a strong shear deformation type structural instability which modifies the properties. Specifically, we find that normal tensile strain leads to structural instabilities with a large induced shear deformation in (...

Mechanical behaviour of unsaturated polyester resin used for the composite materials has been studied to determine various important parameters, such as tensile and compressive, single edge-notch tensile fracture toughness, flexural properties and fracture energy. Fracture toughness, KIC, and fracture energy, GIC, obtained for the polyester resin lie between the typical values for epoxy resins ...

The ultimate tensile behaviour of fibre-reinforced cementitious composites is closely related to its failure mechanisms which in turn are dependent on reinforcement parameters such as fibre characteristics and the fibre/matrix interface properties. Based on the direct tensile tests of mortar specimens reinforced with various synthetic fibres, this paper attempts to explain such relationships an...

.................................................................................................................................................................. 2 Introduction ............................................................................................................................................................ 2 Materials and Methods .........................................