Using a transient hot-wire method, the thermal conductivity of the CaO–SiO2–B2O3 mold flux system was measured. The effects of temperature, BO1.5 concentration and basicity on the thermal conductivity were considered, along with structural investigation by Raman spectroscopy. It was found that the addition of boron oxide caused both a decrement and increment of thermal conductivity, depending o...

Interatomic potentials, which describe interactions between elements of nanosystems, are crucial in theoretical study of their physical properties. We focus on two well known empirical potentials, i.e. Tersoff's and Brenner's potentials, and compare their performance in calculation of thermal transport in carbon nanotubes. In this way, we study the temperature and diameter dependence of thermal...

We present thermal conductivity measurements of micromachined 500 nm thick silicon-nitride Si–N beams suspended between two Si–N islands, in the temperature range from 77 to 325 K. The measured thermal conductivity, k, of Si–N at high temperatures is in good agreement with previously measured values for Si–N grown by low-pressure chemical vapor deposition, but behaves much differently as temper...

Flame stability inside a cylindrical micro-combustor was studied. Considering occurrence of heat recirculation, the respective relations were written and with parameters such as motion speed of reactants, flame propagation speed and thermal conductivity of the combustor’s wall, flame stability and its location inside micro-combustor were studied. It was found that for each thermal conductivity ...

to design the equipment and facilities for preservation, storage and processing of pomegranate, it is necessary to know the specific heat and thermal conductivity of the fruit components. the specific heat of exocarp, mesocarp and of seeds of pomegranate were assessed at three moisture content levels (30, 50 and 76% for seed and mesocarp; 15, 35 and 52% for exocarp) and at four temperature leve...

Thermal adhesives that contain large concentrations of high thermal conductivity filler materials, such as ceramics or metals, are widely used by the electronics industries in a variety of applications. The thermal properties of these materials, such as the thermal contact resistance across a bonded joint and the thermal conductivity of the bulk material, are critical to the selection of the “b...

Several trillion cigarettes produced worldwide annually lead to many thousands of kilograms of toxic waste. Cigarette butts (CBs) accumulate in the environment due to the poor biodegradability of the cellulose acetate filters. This paper presents some of the results from a continuing study on recycling CBs into fired clay bricks. Physico-mechanical properties of fired clay bricks manufactured w...

Bi2Te3 thermoelectric materials are utilized for refrigeration for decades, while their application of energy harvesting requires stable thermoelectric and mechanical performances at elevated temperatures. This work reveals that a steady zT of ≈0.85 at 200 to 300 °C can be achieved by doping small amounts of copper iodide (CuI) in Bi2Te2.2Se0.8-silicon carbide (SiC) composites, where SiC nanodi...

We present an ab initio study which identifies dominant effects leading to thermal conductivity reductions in carbon and boron-nitride nanotubes with isotope disorder. Our analysis reveals that, contrary to previous speculations, localization effects cannot be observed in the thermal conductivity measurements. Observable reduction of the thermal conductivity is mostly due to diffusive scatterin...

An industrial ceramic thermal-barrier coating designated PWA 266, processed by electron-beam physical-vapor deposition, was measured using a steady-state thermal conductivity technique. The thermal conductivity of the mass fraction 7 % yttria-stabilized zirconia coating was measured from 100 °C to 900 °C. Measurements on three thicknesses of coatings, 170 μm, 350 μm, and 510 μm resulted in ther...