In this work, Al-20Si-10Fe-6Cr and Al-20Si-10Fe-6Mn (wt %) alloys were prepared by a combination of short-term mechanical alloying and spark plasma sintering. The microstructure was composed of homogeneously dispersed intermetallic particles forming composite-like structures. X-ray diffraction analysis and TEM + EDS analysis determined that the α-Al along with α-Al15(Fe,Cr)₃Si₂ or α-Al15(Fe,Mn)...

Cu-Zn alloys have been electrodeposited from a pyrophosphate electrolyte containing Cu2P207> Zn2P207 salts and an excess of K4P2O7 and KN03. Current-potential data for both copper and zinc, as well their plating current efficiencies were determined from electrochemical polarisation experiments. Copper deposition commenced at potentials below -0.208 V whereas zinc was deposited only below -1.157...

Previous work has shown the beneficial effect of yttrium implantation on the oxidation behaviour of chromium oxide forming alloys. Because of the limited applicabihty of Fe-Cr-Ni alloys in sulphur containing gases the effect of yttrium implantation on the aulphidation of Incoloy 800H was studied. In short time tests a significant improvement was observed upon implantation of about 10lh yttrium ...

A discontinuously reinforced MMC containing 12 vol % Sic particles in an Al-Cu-Mg alloy (AA 2124) matrix has been diffusion bonded. Thick interlayers of different superplastic aluminium alloys (Al-Li 8090 and A1-Cu SUPRAL) were used to reduce the bonding pressure and ensure complete surface contact. Microstructural studies shown higher continuity in joints bonded with 8090 interlayer than with ...

The research work examined the effect of the removal of iron from aluminium-silicon alloys using dopants on the structure and mechanical properties. Manganese, cobalt and molybdenum were used as the modifying elements. The as-cast Al Si alloys were analyzed for iron content using Atomic Absorption Spectrometer (AAS) technique. The dopants or modifying elements were added as micro additives at v...

Atomic substitution in alloys can efficiently scatter phonons, thereby reducing the thermal conductivity in crystalline solids to the "alloy limit." Using In0.53Ga0.47As containing ErAs nanoparticles, we demonstrate thermal conductivity reduction by almost a factor of 2 below the alloy limit and a corresponding increase in the thermoelectric figure of merit by a factor of 2. A theoretical model...

The influences of minor Cu addition (2 and 4 at.%) on the microstructural evolution room-temperature mechanical property metastable Co35Cr25Fe30Ni10 are systemically investigated in present study. results indicate that thermally induced hexagonal close-packed (HCP) phase is absent when was added, due to increase stacking fault energy (SFE). 2%-Cu-added alloys showed largest total elongation 69%...

s The purpose of this study was carried out by the embryotoxicity risk assessment of the dental alloys containing indium. We produced Ag-In alloy, Ag-Pd-Au-Cu alloy and gold alloy for porcelain bonding. For the extraction of these alloy components into the ES-D3 cell culture medium, each alloy was reduced to a powder using a diamond point and sterilized after rinsing. In order to facilitate the...

The present work reports on a positron annihilation study addressing the structural and chemical characterization of solute aggregates containing open volumes (vacancies and/or misfit regions at precipitate–matrix interfaces) in AlZnMg, AlCu, and AlCuMg alloys. High resolution transmission electron microscopy results for selected ageing conditions are also presented. Two main points are discuss...