Operational Transconductance Amplifier (OTA) is one of the most significant building-blocks in integrated continuous-time filters. Here we design Low Power Low Voltage Bulk Driven OTA with a new concept of high-linearity OTA with controllable Transconductance is proposed. The OTA is simulated in a standard TSMC 0.18 mm CMOS process with a 0.6 V supply voltage. 1. INTRODUCTON Low-voltage (LV) an...

This thesis presents the theory, design, layout and a proposal for measurement set up of a synchronous DC-DC buck converter. This converter will be used as the supply modulator of power amplifier of mobile phones. The design is done using 45nm CMOS technology. Pmos and nmos switches are synchronously turns on and off for DC voltage conversion. Second order LC type filter is used to filter out t...

This paper presents a high CMRR and wideband current feedback Instrumentation Amplifier (IA). The proposed IA architecture consists of Fully Balanced Differential Difference Amplifier (FBDDA) and Differential Difference Amplifier (DDA) based on 2 generation current conveyor (CCII) with a buffer. From the simulation results evaluated by HSPICE, the proposed IA exhibits average CMRR was 109.3 dB ...

A low-noise CMOS amplifier operating at a 1-V supply voltage is developed using the two noise reduction techniques of autozeroing and chopper stabilization. The proposed amplifier utilizes a feedback with virtual grounded input-switches and a multiple-output switched op-amp. The low-noise amplifier fabricated by a 0.18-μm CMOS technology was measured at a 1-V power supply, and achieved low nois...

This paper describes the design of a current mode instrumentation amplifier using second generation current conveyor(CCII). The current mode approach offers several advantages such as high speed, better noise performance and lower power consumption as compared to conventional voltage mode approach. The design is implemented in standard 65 nm CMOS technology. Simulation is done in cadence enviro...

This paper describes a CMOS voltage reference circuit which occupies small die area and has less than 1.25 V of output voltage. The reference voltage is determined by a resistor ratio, and it is possible to set the reference voltage from zero to near the supply voltage with the same temperature independence as those of Widlar’s and Brokaw’s bandgap voltage references. The temperature-independen...