This study analyzes actuator disc (AD) models of horizontal-axis turbines to determine optimal performance, defined as the maximum power extracted at any tip speed ratio. We use calculus variations maximize rotor torque relative thrust without making assumptions about loading. The was obtained from angular momentum equation and Kutta-Joukowsky which depends on circumferential velocity optimalit...

The present work experimentally investigates the thermal effects of a synthetic jet actuator on the heat transfer performance of single-phase flow confined in a microchannel heat sink. The heat sink consisted of a single rectangular microchannel 500 μm wide, 300 μm deep and 26 mm long. Deionized water was employed as the cooling fluid. A synthetic jet actuator with a 100 μm diameter orifice was...

Hydrodynamic modelling is an important tool for the development of tidal stream energy projects. Many hydrodynamic models incorporate the effect of tidal turbines through an enhanced bottom drag. In this paper we show that although for coarse grid resolutions (kilometre scale) the resulting force exerted on the flow agrees well with the theoretical value, the force starts decreasing with decrea...

Technological obstacles to the use of rotary-type swing arm actuators to actuate optical pickup modules in small-form-factor (SFF) disk drives stem from a hinge's skewed actuation, subsequently inducing off-axis aberrations and deteriorating optical quality. This work describes a dual-stage seesaw-swivel actuator for optical pickup actuation. A triple-layered bimorph bender made of piezoelectri...

To clarify the behavior of the blade tip vortices of a wind turbine equipped with a brimmed-diffuser shroud, called a “Wind-Lens turbine”, we conducted a three-dimensional numerical simulation using a large eddy simulation (LES). Since this unique wind turbine consists of not only rotating blades but also a diffuser shroud with a broad-ring brim at the exit periphery, the flow field around the ...

The state of the art engineering dynamic inflow models of Pitt-Peters, Øye and ECN have been used to correct Blade Element Momentum theory for unsteady load prediction of a wind turbine for two decades. However, their accuracy is unknown. This paper is to benchmark the performance of these engineering models by experimental and numerical methods. The experimental load and flow measurements of a...

OBJECTIVE In a univentricular Fontan circulation, modest augmentation of existing cavopulmonary pressure head (2-5 mm Hg) would reduce systemic venous pressure, increase ventricular filling, and thus substantially improve circulatory status. An ideal means of providing mechanical cavopulmonary support does not exist. We hypothesized that a viscous impeller pump, based on the von Kármán viscous ...