In an experimental study of laser sheet bending, a 160W diode laser is used for twodimensional sheet bending of low-carbon steel. The variables investigated include metal sheet thickness, laser scan speed, laser power, laser beam width, and laser scan pass number. Bend surface appearances are also analysed. The laser sheet bend results demonstrate that a 940Nm diode laser is an effective tool f...

The modeling of flood-induced bend scour near embankment toes can provide important information for river engineering, embankment safety warnings, and emergency action management. During the rainy seasons, short-term general scour and bend scour are the most common causes for the failure of reinforced concrete embankments in Taiwan. To gain a deeper understanding of the scouring process near le...

We investigate edge-intersection graphs of paths in the plane grid regarding a parameter called the bend-number. The bend-number is related to the interval-number and the track-number of a graph. We provide new upper and lower bounds of the bend-number of any given simple graph in terms of the coloring number, edge clique covers and the maximum degree. We show that the bend-number of an outerpl...

The families EPT (resp. EPG) Edge Intersection Graphs of Paths in a tree (resp. in a grid) are well studied graph classes. Recently we introduced the graph classes Edge-Intersecting and Non-Splitting Paths in a Tree (ENPT), and in a Grid (ENPG). It was shown that ENPG contains an infinite hierarchy of subclasses that are obtained by restricting the number of bends in the paths. Motivated by thi...

In river meandering, when flow passes through a bend, reduction of flow velocity and rising hydrostatic pressure cause super elevation phenomena at outer side and reduction of water surface at inner-side of the bend. A helical motion results, causing erosion of the outer side of the bend. Installation of submerged vanes on the stream bed can reduce erosion of the outer bank significantly. In th...

This study investigated whether the "constant limb force" hypothesis can be applied to bend sprinting on an athletics track and to understand how force production influences performance on the bend compared with the straight. Force and three-dimensional video analyses were conducted on seven competitive athletes during maximal effort sprinting on the bend (radius 37.72 m) and straight. Left ste...

Bend sensors have been developed based on conductive ink, optical fiber, and electronic textiles. Each type has advantages and disadvantages in terms of performance, ease of use, and cost. This study proposes a new and low-cost bend sensor that can measure a wide range of accumulated bend angles with large curvatures. This bend sensor utilizes a Bowden-cable, which consists of a coil sheath and...