Room-and-pillar mining with pillar recovery has historically been associated with more than 25% of all ground fall fatalities in underground coal mines in the United States. The risk of ground falls during pillar recovery increases in multiple-seam mining conditions. The hazards associated with pillar recovery in multiple-seam mining include roof cutters, roof falls, rib rolls, coal outbursts, ...

Canister desorption is a widely used technique to measure the gas content of coal. The gas content data, when normalized to volume/weight and multiplied by coal seam mass, is used to estimate the gas in place in an area around the cored hole. However, the gas content and the percentage of each constituent are likely to be influenced by trapped air in the canister at the time of the coal enclosu...

canister desorption is a widely used technique to measure the gas content of coal. the gas content data, when normalized to volume/weight and multiplied by coal seam mass, is used to estimate the gas in place in an area around the cored hole. however, the gas content and the percentage of each constituent are likely to be influenced by trapped air in the canister at the time of the coal enclosu...

Increasing the production rate and minimizing the related costs, while optimizing the safety measures, are nowadays’ most important tasks in the mining industry. To these ends, mechanization of mines could be applied, which can result in significant cost reductions and higher levels of profitability for underground mines. The potential of a coal mine mechanization depends on some important fact...

Coal seam gas (CSG) is the extraction of methane gas that is desorbed from the coal seam and brought to the surface using a dewatering and depressurisation process within the saturated coalbed. The extracted water is often referred to as co-produced CSG water. In this study, co-produced water from the coal seam of the Bowen Basin (QLD, Australia) was characterised by high concentration levels o...

Studies have shown that, coal seam, an un-conventional reservoir, is considered as a promising option for CO2 sequestration because of its large CO2 sequestration capacity, long time CO2 trapping and extra enhanced coal-bed methane (ECBM) production benefits. However, unlike conventional reservoirs, gas flow in the coal seam can cause the cleat permeability and porosity change during the inject...

There are many coal seams in high-gas mining area of China. The permeability is low. The gas extraction from the original coal seam is difficult and the commercial value is little. The conception of the safe high-efficient exploitation of coal and gas is put forward in this article. It changes the conventional exploitation sequence that is from the upper to below. When we exploit coal seams, th...

The availability of renewable energy does not meet the demands of consumption. Hence, fossil fuels will continue to be an important energy source, and coal promises to cover the requirements for the coming decades. Because of its high energy content, deep lying bituminous coal and anthracite are important for energy generation. One trend in the future of coal mining is thin seam mining, because...

Hydrocarbon wells drilled vertically through longwall coal pillars are vulnerable to severe deformation and potential failure as a result of underground coal mining. The lithology of the host rocks play a critical role in well stability. In this study, a two dimensional finite element method is employed to investigate the horizontal shear offset, vertical delamination, and compression at the we...

Injecting water into a coal seam to enhance the cohesive strength of coal and thus minimize and reduce the coal wall spalling risk must be considered in underground coal mining systems. In general, coal with low cohesive strength contains clay minerals which may affect the stability of coal by interacting with water. Therefore, the coupled effects of moisture content and inherent clay minerals ...