In an earlier paper it was suggested that a knowledge of the elastic-stress variation in the neighborhood of an angular corner of an infinite plate would perhaps be of value in analyzing the stress distribution at the base of a V-notch. As a part of a more general study, the specific case of a zero-angle notch, or crack, was carried out to supplement results obtained by other investigators. Thi...

existence of cracks in industrial structures is one of the important causes of their failure, especially when they are subjected to important axial compressive forces that might lead to buckling. therefore, it must be considered in stress analysis and designing and loading of such structures. in this paper, the buckling and post-buckling behaviors of stainless-steel cracked plates under axial c...

The plane problem of a crack terminating at the interface of a bimaterial piezoelectl:ic, and loaded on its fa.ces, is treated. The emphasis is placed on how to transform this problem into a non-homogeneous Hilbert problem. To make the derivation tractable, the concept of the axial conjugate is introduced and related to the complex conjugate. The angle between the crack line and the interface m...

The study of vibration response of a turbine blade helps to detect the crack presence in the blade which alters its dynamic characteristics. The change is characterized by changes in the modal parameters associated with natural frequencies. In this paper, study of vibration response is made for turbine blade in the presence of a crack like defect. Turbine blade is initially assumed as a cantile...

river bank erosion can result in considerable riparian land loss and the delivery of large volumes of sediment to reaches downstream. consequently, the ability to predict the stability and failure geometry of eroding river banks is an important prerequisite for es-timating the rate of bank erosion and sediment yield associated with bank erosion. in this paper a new model capable of analyzing th...

The fatigue crack growth in a coarse-grained Fe-2 wt% Si alloy is investigated in considerable detail. At room temperature, the material is quasi-brittle and the failure mode is mixed cleavage. Under a mode-I cyclic loading, the crack can overcome the barrier effect of grain boundaries, which dominates the overall damage evolution. Associated with the geometrically necessary crack front branchi...

A novel method for preparing and testing bending specimens in-situ the TEM has been developed. This method provides high visibility of the crack front and its associated plastic zone. This is significant because energy release rates can now be calculated at many points throughout the test based on crack tip opening displacement (CTOD), crack opening angle (COA), and crack advance. Further refin...

Ultrasonic methods have been implemented for in situ sizing of fatigue cracks near fastener holes. These techniques, however, only provide an estimate at the time of the measurement and cannot predict the remaining life of the structure. In contrast, statistical crack propagation approaches model the expected fatigue life based on worst-case fatigue process assumptions. The authors have recentl...

In order to investigate the properties of Y-shaped cracks of brittle materials under compression, compression tests by using square cement mortar specimens with Y-shaped crack were conducted. A true triaxial loading device was applied in the tests, and the major principle stresses or the critical stresses were measured. The results show that as the branch angle θ between the branch crack and th...

A crack trapping model is developed for the fracture resistance of high-angle grain boundaries in free-standing brittle thin films, based on which a new size effect is predicted. In addition to the crystallographic misorientations, the grain boundary toughness is also dependent on the film thickness, primarily due to the geometrically necessary crack front branching. 2007 Elsevier Ltd. All righ...