This paper presents the analysin ,design and implementation of a high voltage ratio topology of DC-DC converter. The DC-DC converter has high voltage ratio with reduced input current, output voltage and output current ripple, and also reduces the voltage and current rating of power electronics components and compared with conventional boost converter. The voltage stress on the switches are  red...

In this paper fractional order averaged model for DC/DC Buck converter in continues condition mode (CCM) operation is established. DC/DC Buck converter is one of the main components in the wind turbine system which is used in this research. Due to some practical restriction there weren’t exist input voltage and duty cycle of converter therefor whole of the wind system was simulated in Matlab/Si...

This paper presents an off-line integrated full ballast to supply a 35 W assembly of Power LEDs. The proposed solution integrates an input PFC stage (a flyback converter operating in DCM) and a DC-DC output converter (a buck converter) into a single switch power stage, operating with peak current control. As it will be shown, this control scheme maintains the current through the load constant, ...

MOSFET is the most commonly used devices in DC-DC power converters, and its performance is important to the prognosis and health management of power. The paper proposes a degradation analysis model for MOSFET in DC-DC power converters. A method for detecting the degradation of MOSFET is also introduced. Simulations have shown that the method can predict deterioration in the performance of MOSFE...

This paper presents the development of a high gain Boost converter applied to photovoltaic (PV) system. The converter was designed to be connected directly to the photovoltaic panel and perform the search for the maximum power point (MPPT). The new proposal seeks the MPPT is to connect each panel a converter for a high gain greater accuracy in finding the point of maximum power. The converter w...

DC-DC converters are switched power converters. They are used to convert one DC voltage to another DC voltage. It is inordinately used in industry as well as in research. The model of converter system varies from the ON state to the OFF state. The major drawback of the boost converter is the uncontrolled supply of voltage and current. So initially a convectional PID controller is designed to re...

This paper proposes a high voltage ratio and low ripple interleaved boost DC-DC converter, which can be used to reduce the output voltage ripple. This converter transfers the low DC voltage of fuel cell to high DC voltage in DC link. The structure of the converter is parallel with two voltage-doublers boost converters by interleaving their output voltages to reduce the voltage ripple ratio. Bes...

For battery-powered electronic products, one way to extend battery life is to use a versatile step-up/step-down DC-DC converter. A new versatile step-up/step-down switched-capacitor-based converter structure is proposed, and its efficiency is analyzed. In the step-down case, the efficiency is the same as, or even better than the efficiency of linear regulators. key words: DC-DC converter, switc...

A method for designing power line filters for SMPS is presented. The practical design work is optimized, by excluding the nonviable combinations of filter components. The designer can choose among the theoretically viable combinations, to try practical designs. The theoretical calculations are based on chain parameters. As an illustration of the method a single stage π-filter for a buck convert...

Switched Capacitor DC-DC Converter: Superior where the Buck Converter has Dominated