The rapid printing of 3D parts with desired electrical properties enables numerous applications. Fused deposition modeling (FDM) using conductive thermoplastic composites has been a valuable approach for such fabrication. The parts produced by FDM possess various controllable structural features, but the effects of the structural features on the electrical properties remain to be determined. Th...

This paper reports the correlation between film thickness, nanostructure and DC electrical properties of copper thin films deposited by PVD method on glass substrate. X-ray diffraction (XRD) and atomic force microscopy (AFM) were used for crystallography and morphology investigation, respectively. Resistivity was measured by four point probe instrument, while a Hall effects measurement system w...

Of the several thermal, mechanical and hydrological measurements being used to monitor the rockmass response in the Single Heater Test, electrical resistance tomography (ERT) is being used to monitor the movement of liquid water with a special interest in the movement of condensate out of the system. Images of resistivity change were calculated using data collected before, during and after the ...

protection of water resources from contamination and detection of the contaminants and their treatments are among the essential issues in the management of water resources. in this work, the time-lapse electrical resistivity tomography (ert) surveys were conducted along 7 longitudinal lines in the downstream of the latian dam in jajrood (iran), in order to detect the contamination resulting fro...

The formation resistivity factor evaluation of brine-filled reservoir rock is an essential part of electrical resistivity log interpretation in petroleum exploration. Empirical relations such as Archie’s law are widely employed to model the relationship between the formation resistivity factor and porosity. Historically, the Archie cementation exponent has been obtained from experimental labora...

Temperature dependent electrical resistivity, crystal structure and heat capacity measurements reveal a resistivity drop and electrical transport behavior change corresponding to a structural change near 400 K in Ca(3)Co(4)O(9). The lattice parameter c varies smoothly with increasing temperature while anomalies in a, b(1) and b(2) lattice parameters occur near 400 K. The Ca site in the Ca(2)CoO...

Slugging flow in offshore oil & gas multi-phase transportation pipelines cause big challenges as the flow regime induces flow and pressure oscillations in the multi-phase pipelines. The negative impacts of the most severe slugs are significant and thus the elimination of slugging flow in the pipelines is a highly investigated topic. To eliminate the slug in an online manner real-time slug detec...