Powder-liquid type metal-resin composites, using Ag-Sn irregular particles as the filler, 4-META as coupling agent and UDMA + TEGDMA as resin matrix, were experimentally prepared under 9 different conditions (three different particle sizes and three different filler contents). The flexural strength and flexural modulus were measured. Three different irregular particle size MRCs without redox-in...

Abstract: The investigation is carried out to characterize welding of AISI 310 austenitic stainless steel to Inconel 657 nickel-chromium superalloy. The welds were produced using four types of filler materials: the nickel-based corresponding to Inconel 82, Inconel A, Inconel 617 and austenitic stainless steel 310. This paper describes the effects of aging treatment on the joint. The compara...

The joining of wires to various substrates (wires, plates, foils and semiconductor packages) is a ubiquitous process in the manufacture and modification of electrical and electronic devices. While spot welding is used extensively to attach lamp and vacuum tube filaments to base wires and foils, soldering is almost universally used to make chip to package and wire to substrate interconnections i...

Article history: Received: 4.9.2015. Received in revised form: 1.12.2015. Accepted: 2.12.2015. This research paper deals with the joining of different materials such as SiCp/6063Al MMCs and Fe-Ni alloys by means of vacuum brazing with active filler metal Ag47-Cu18-In17-Sn17-Ti1. With the optimal process parameters, i.e., brazing temperature 580 °C, soaking time of 30 min and vacuum degree of 6....

In the present study, the microstructure and mechanical properties of the dissimilar welding between ASTM A335 low alloy steel and ER309L austenitic stainless steel were investigated using the gas tungsten arc welding process. The welding of dissimilar materials between ASTM A335 low alloy steel and ER309L austenitic stainless steel was found to have a significant effect on the microstructure w...

in the present study, the microstructure and mechanical properties of the dissimilar welding betweenastm a335 low alloy steel and er309l austenitic stainless steel were investigated using the gastungsten arc welding process. the welding of dissimilar materials between astm a335 low alloy steeland er309l austenitic stainless steel was found to have a significant effect on the microstructure when...

Cracking is a major concern in welding aluminum alloys. Although weld solidification cracks can be eliminated through the addition of filler metal, the additives modify the alloy or base metal constituents and may not always be desirable. High-energy beam processes, such as electron beam welding, that result in minimal heat input reduce crack sensitivity, but their high cost limits their applic...

Thermal properties—such as thermal conductivity, thermal diffusivity, and specific heat—of metal (copper, zinc, iron, and bronze) powder-filled high-density polyethylene composites are investigated experimentally in the range of filler content 0–24% by volume. Experimental results show a region of low particle content, 0–16% by volume, where the particles are distributed homogeneously in the po...