To achieve high thermal efficiency in modern gas turbines, the turbine-inlet temperature has to be increased. In response to such requisites and to prevent thermal failure of the components exposed to hot gas streams, the use of different cooling techniques, including film cooling, is essential. Finding an optimum film cooling design has become a challenge as it is influenced by a large number ...

the present article focuses on the evaluation of a first-moment closure model applicable to film cooling flow and heat transfer computations. the present first-moment closure model consists of a higher level of turbulent heat flux modeling in which two additional transport equations for temperature variance kθ and its dissipation rate εθ are considered. it not only employs a time scale that is ...

An experimental study was performed to examine effects of compressibility on film cooling effectiveness for coolant flowing from cylindrical holes in a flat plate. The incoming flow Mach number was set at 0.07, 0.30, 0.50 and 0.70. The Pressure Sensitive Paint (PSP) technique, which is based on a mass transfer analogy, was used to map the adiabatic film cooling effectiveness distribution on the...

Effective cooling of gas turbine combustor liners, combustor transition pieces, turbine vanes (nozzles) and blades (buckets) is a critical task to protect these components from the flue gas at extremely high temperature. Air film cooling has been successfully used to cool these hot sections for the last half century. However, the net benefits from the traditional methods seem to be marginally i...

Cooling of gas turbine hot section components such as combustor liners, combustor transition pieces, turbine vanes (nozzles) and blades (buckets) is a critical task for improving the life and reliability of hotsection components. Conventional cooling techniques using air-film cooling, impingement jet cooling, and turbulators have significantly contributed to cooling enhancements in the past. Ho...

In film cooling experimental studies, due to the difficulty in measuring the surface heat flux variation, a Heat Flux Ratio (HFR) equation originally derived by Mick and Mayle [1], has been widely employed to calculate the surface heat flux distribution using the measured adiabatic film effectiveness and surface temperature. A close examination of the derivation process and applications of the ...

We have used variable cooling rate ellipsometric measurements to probe the slow dynamics in thin supported polystyrene films. For the slowest cooling rates (approximately 1 K/min) the measured Tg values are reduced below the bulk value with the measured Tg of 341 K for a 6 nm film. As the cooling rate is increased the Tg reductions become smaller until at cooling rates >90 K/min there is only s...

This work presents a comparison of thin film gauge (TFG) and infrared (IR) thermography measurement techniques to simultaneously determine heat transfer coefficient and film cooling effectiveness. The first comparison was with an uncooled vane where heat transfer coefficient was measured at Mex=0.77 and Tu=16%. Relatively good agreement was found between the results of the two methods and the e...

In this study, the effect of randomness of blowing ratio on film cooling performance is investigated by combining direct numerical simulations with a stochastic collocation approach. The geometry includes a 35-deg inclined jet with a plenum attached to it. The blowing ratio variations are assumed to have a truncated Gaussian distribution with mean of 0.3 and the standard variation of approximat...

The present article focuses on the evaluation of a first-moment closure model applicable to film cooling flow and heat transfer computations. The present first-moment closure model consists of a higher level of turbulent heat flux modeling in which two additional transport equations for temperature variance kθ and its dissipation rate εθ are ...