Abstract The suspected circumferential weld defects found in the pipeline inspection process were tested and studied. It was that there slag inclusion girth at 9 o’clock, which had not been early stage or laboratory nondestructive testing process. are most likely due to incomplete removal between layers low welding wire energy. There a root crack 6 o’clock position of weld, length 10 mm, close ...

Data on body weight and body measurements (body length, height at withers, chest girth and paunch girth) of adult Kilakarsal sheep have been collected from 124 adult animals managed at the farmers filed in Tirunelveli districts of Tami Nadu, India to estimate the body weight from body measurements. The data were subjected to standard statistical analysis using SPSS software and linear regressio...

Tungsten inert gas (TIG) welding, also called as gas tungsten welding 1. (a) Schematic of TIG welding Process (b) Variety of tungsten electrodes. The activated TIG (ATIG) welding process mainly focuses on increasing the depth of penetration and the reduction in the width of weld bead has not been paid. Tungsten inert gas welding, TIG is widely applied in manufacturing process for different The ...

Gas tungsten arc welding (GTAW) or Tungsten inert gas welding (TIG) is one of the widely used techniques for joining ferrous and non-ferrous metal.Gas tungsten arc welding process,consist of non-consumable tungsten electrode which is used to provide the arc for welding. During the welding cycle a shield of inert gas expels the air from the welding area and prevents oxidation of the electrode, w...

This paper provides a general introduction to welding fundamentals (section 2) followed by sections on a few selected welding processes that have had significant developments or improvements over the last few years. The processes that are discussed are friction welding (section 3), hot plate welding (section 4), ultrasonic welding (section 5), laser/IR welding (section 6), RF welding (section 7...

Abstract Maintaining the minimum allowable distance between proximity welds has always been considered a subject of debate among design engineers, welding engineers/inspectors and fabricators/engineering contractors. The scattered nature guidelines available in codes standards for maintaining poses significant challenge procedure inspection criteria development process. This is especially criti...

Submerged arc welding is preferred over other methods of welding because of its inherent qualities like easy control of process variables, high quality, deep penetration, smooth finish, capability to weld thicker sections. Since the development of submerged arc welding process, welding engineers are striving for reduction in welding cost without compromise in the performance of the weld. Flux u...

In this study, the effect of various welding parameters on the weldability of Mild Steel specimens having dimensions 50mm× 40mm× 6 mm welded by metal arc welding were investigated. The welding current, arc voltage, welding speed, heat input rate are chosen as welding parameters. The depth of penetrations were measured for each specimen after the welding operation on closed butt joint and the ef...

The objective of this study was to characterize personal exposures to welding-related metals and gases for production welders and non-welders in a large manufacturing facility. Welding fume metals and irritant gases nitrogen dioxide (NO2) and ozone (O3) were sampled for thirty-eight workers. Personal exposure air samples for welding fume metals were collected on 37 mm open face cassettes and ni...

Laser beam welding has wide acceptability due to least welding distortion, low labour costs and convenient operation. However, laser welding for dissimilar titanium and aluminium alloys is a new area which is having wider applications in aerospace, aircraft, automotive, electronics and other industries. The present study is concerned with welding parameters namely laser power, welding speed, fo...