Influence of a vent hood at the exit of exhaust flue gas and flue baffles in the firetube on the temperature and flow fields of a gas tank water heater, as well as thestructure and amount of heat transferred to the water tank has been studiednumerically using two-dimensional steady state finite element simulation.Observations show that without a vent hood, there is a downward gas flow in theflu...

A novel surface ionization detector using a reducing quartz liner and a Mo emitter with a quartz enclosed internal heater for selective measurement of alkylamines by gas chromatography is designed and evaluated.

A new measurement technique for the determination of the heat transfer coefficient and the film cooling effectiveness is presented. It is based on a regression of multiple transient liquid crystals experiments using an electrical heater-foil producing a nonhomogeneous surface heat flux. This is particularly interesting for film-cooled surfaces where each cooling hole in the heater-foil leads to...

Flow sensors commonly are used in, for example, micro liquid handling systems or for measuring gas flows. One example is a gas flow sensor used as a microphone: the Microflown [3]. This sensor is designed to measure particle velocity, very small flows in a frequency range up to twenty kilo Hertz. While the signal to noise ratio is a very important parameter of the microflown an innovative measu...

Previous chemical heater designs for isothermal nucleic acid amplification have been based on solid-liquid phase transition, but using this approach, developers have identified design challenges en route to developing a low-cost, disposable device. Here, we demonstrate the feasibility of a new heater configuration suitable for isothermal amplification in which one reactant of an exothermic reac...

The study investigates the fabrication and characterization of an ethanol microsensor equipped with a heater. The ethanol sensor is manufactured using the commercial 0.18 µm complementary metal oxide semiconductor (CMOS) process. The sensor consists of a sensitive film, a heater and interdigitated electrodes. The sensitive film is zinc oxide prepared by the sol-gel method, and it is coated on t...

The design and fabrication of an ethanol microsensor integrated with a readout circuit on-a-chip using the complementary metal oxide semiconductor (CMOS)-microelectro -mechanical system (MEMS) technique are investigated. The ethanol sensor is made up of a heater, a sensitive film and interdigitated electrodes. The sensitive film is tin dioxide that is prepared by the sol-gel method. The heater ...

A methanol microsensor integrated with a micro heater manufactured using the complementary metal oxide semiconductor (CMOS)-microelectromechanical system (MEMS) technique was presented. The sensor has a capability of detecting low concentration methanol gas. Structure of the sensor is composed of interdigitated electrodes, a sensitive film and a heater. The heater located under the interdigitat...

A simulation model for the CO2 heat pump water heater was developed and validated in this study. Component models of the gas cooler, evaporator, compressor, and expansion valve were constructed with careful consideration for the heat transfer performances. To validate the simulation model, experiments were carried out using an actual CO2 heat pump water heater (water heating capacity: 22.3 kW; ...

For the first time, 3D multiphysics finite element modelling has been used to optimise the geometry of a calorimetric thermal flow sensor. The model involves and couples three physics domains: electric, thermal and fluid mechanics. The model is validated against experimental data obtained from a thermoelectronic flow sensor comprising of a tungsten heating resistor and temperature sensing diode...