Power input to the arc in gas metal arc welding controls both the metal transfer process and the base-plate heating process. It would be advantageous to decouple these processes. Methods to achieve this decoupling are discussed. Pulsed-power welding is widely used, but only decoupling can be achieved. More complete decoupling may be obtained by using independent power inputs to the system. Seve...

Welding is an important manufacturing process that can be automated and optimized. This paper focuses on the development of a robotic arc welding system, wherein a three-degreeof-freedom Selective Compliance Assembly Robot Arm (SCARA) is interfaced to a Gas Metal Arc Welding (GMAW) process. The entire system is composed of a robot linked to a GMAW system. Set points are derived using the desire...

It was generally observed that welders in Calabar, Nigeria did not always wear their protective goggles during welding. Since chronic exposure to welding light can impair vision this study was done to assess the effect of exposure to welding light on ocular function of welders in Calabar, Nigeria. There were 195 subjects comprising 110 welders (test) and 85 control subjects. Both groups were al...

unlike traditional power grids, smart grids have the advantage of bidirectional power flow and having distributed generations. distributed generation systems are usually supplied by renewable sources which can cause unpredicted voltage fluctuations as a result of being intermittent. while traditional compensating devices deal with the problem of voltage fluctuation and reduced power quality wit...

Soft-switching DC-DC converter using Phase-Shifted Pulse Width Modulation (PS-PWM) on secondary side of highfrequency transformer is described in the paper. The converter consists of a full-bridge inverter fitted with fast IGBT transistors. The output power of the converter is controlled by rectifier made up of two snap-off diodes in series with MOSFET transistors which is connected on secondar...

D. Bajic, University of Montenegro, Faculty of Mechanical Engineering, G. Vladimirovich Kuzmenko, E.O. Paton Electric Welding Institute, National Academy of Sciences Ukraine, I. Samardžić, J.J.Strossmayer university of Osijek, Mechanical Engineering Faculty in Slavonski Brod, Croatia The paper presents up-to-date achievements in application of a new method of arc welding of various rail profi l...

A circuit of a multi-phase active power filter based on multi-stage inverter architecture was introduced. The paper is focused on building the MATLAB / Simulink model of an AC power supply system including a single-phase active power filter with a two-stage inverter. Each stage of the filter uses the pulsewidth modulation (PWM) method. The results confirmed high efficiency of such a compensatin...

Arc sensors have been used in seam tracking and widely studied since the 80s and commercial arc sensing products for T and V shaped grooves have been developed. However, it is difficult to use these arc sensors in narrow gap welding because the arc stability and sensing accuracy are not satisfactory. Pulse gas melting arc welding (P-GMAW) has been successfully applied in narrow gap welding and ...