To ensure an adequate clinical composite filling light source for photopolymerization is of great importance. In everyday clinical conditions commonly used unit for polymerization of composite material is halogen curing unit. The development of new blue superbright light emitting diodes (LED) of 470 nm wavelengths comes as an alternative to standard halogen curing unit of 450-470 nm wavelengths...

This study determined the hardness and curing depth of a light-activated indirect composite polymerized with three laboratory light-polymerizing units for the purpose of comparing the curing performance of the three units. A light-activated composite material for indirect application (Vita Zeta) was polymerized with three light-polymerizing units equipped with the following light sources: 1) on...

objectives: the aim of this in-vitro study was to assess the thermal effect of light emitting diode (led) light curing unit on the enamel etching time. materials and methods: three treatment groups with 15 enamel specimens each were used in this study: g1: fifteen seconds of etching, g2: five seconds of etching, g3: five seconds of etching plus led light irradiation (simultaneously). the micro ...

Introduction: One factor affecting the degree of polymerization is the type of light-curing device. The aim of this study was to compare the effects of LED and QTH light curing units on the surface hardness of composite and compomer. Materials & Methods: In this experimental study, 30 samples of composite and compomer were divided into 3 groups of 10 each. One-half of the subgroups in each g...

This study evaluated the effect of blue light emitting diode (LED) and quartz tungsten halogen (QTH) on the degree of conversion (DC) of an etch-and-rinse Single Bond adhesive system (SB) and a mixture composed of primer solution and resin bond from Clearfil SE Bond self-etching adhesive system (CB) using Fourier transform infrared analysis (FTIR). Adhesives were applied to potassium bromide pe...

We present a GPU accelerated toolbox for shaping the light propagation through multimode fibre using a spatial light modulator (SLM). The light is modulated before being coupled to the proximal end of the fibre in order to achieve arbitrary light patterns at the distal end of the fibre. First, the toolbox optimises the acquisition time of the transformation matrix of the fibre by synchronous op...

Aim The aim of this study is to compare and to evaluate effect of curing light and curing modes on the nanohybrid composite resins with conventional Bis-GMA and novel tricyclodecane (TCD) monomers. Methodology Two nanohybrid composites, IPS empress direct and charisma diamond were used in this study. Light-emitting diode (LED)-curing unit and quartz-tungsten-halogen (QTH)-curing unit which we...

We developed a new laboratory polymerizing unit (Twinkle MIII: M3) equipped with different light sources (a metal halide and two halogen lamps) that could illuminate independently. This study introduced the structure of the curing unit and examined the curing depth of a representative indirect composite (Artglass). The composite material was cured with the following modes: 1) M3 - halogen only;...

OBJECTIVES Different light curing units are used for polymerization of composite resins. The aim of this study was to evaluate the degree of conversion (DC) and temperature rise in hybrid and low shrinkage composite resins cured by LED and Argon Laser curing lights. MATERIALS AND METHODS DC was measured using FTIR spectroscopy. For measuring temperature rise, composite resin samples were plac...