To study the influence of impinging height H/D on flow field characteristics oblique submerged jets, numerical calculation an jet was carried out based Wray–Agarwal (W–A) turbulence model. The structure and pressure distribution under various heights (1 ≤ 8) when angle θ = 45° were analyzed. results show that with increase in height, diffusion degree gradually increased velocity decreased reach...

Laminar stagnation flow, axi-symmetrically yet obliquely impinging on a rotating circular cylinder, as well as its heat transfer is formulated as an exact solution of the Navier-Stokes equations. Rotational velocity of the cylinder is time-dependent while the surface transpiration is uniform and steady. The impinging stream is composed of a rotational axial flow superposed onto irrotational rad...

the production of shear flow profile in a wind tunnel test-section with the aid of in-plain horizontal wire-grids is explained. the design procedure with experimental results are given. it is concluded that the deepest shear, produced by this procedure, cannot have a slope of more than 1.777. it is shown that the stagnation streamlines in a shear flow will be displaced due to the existence of s...

Non-isothermal stagnation-point flow with consideration of thermal radiation is studied numerically. A set of partial differential equations that governing the fluid flow and energy is converted into a set of ordinary differential equations which is solved by Runge-Kutta method with shooting algorithm. Dimensionless wall temperature gradient and temperature boundary layer thickness for differen...

It is shown that a slender elastic fiber moving in a Stokesian fluid can be susceptible to a buckling instability--termed the "stretch-coil" instability--when moving in the neighborhood of a hyperbolic stagnation point of the flow. When the stagnation point is part of an extended cellular flow, it is found that immersed fibers can move as random walkers across time-independent closed-streamline...

We investigate the stability of steady planar stagnation flows of a dilute polyethylene oxide (PEO) solution using T-shaped microchannels. The precise flow rate control and well-defined geometries achievable with microfluidic fabrication technologies enable us to make detailed observations of the onset of elastically-driven flow asymmetries in steady flows with strong planar elongational charac...

Temperature is an important parameter in most high speed flow experiments, but it is sometimes a difficult parameter to measure, particularly in short-duration facilities. Stagnation temperature measurements have been obtained using transient thin film heat flux probes in a Mach 6 carbon dioxide flow produced by the Oxford University Gun Tunnel. The probes were operated over a range of surface ...

Monomer precursor flow was introduced at an oblique angle to the substrate two locations during initiated chemical vapor deposition (iCVD) process using a branched nozzle inlet extension. The polymerization of methacrylic acid systematically studied as function length and monomer rate. Our experimental data showed evolution distinct symmetrical thickness profiles rate increased. maximum moved d...