The components of blower are composed of motor and impeller. Motors transform electric energy into mechanical rotating kinetic energy and this rotating kinetic energy produces flow through impeller. And thus blower is divided into motor and impeller. In actual development and study, the process of system formation is followed generally by joining the two independent research results. This study...

this paper tries to determine an optimum condition for the flotation operation of the alborz-sharghi coal washing plant. for this purpose, a series of comprehensive experiments have been conducted on representative samples from feed of the flotation system of the plant. four operational variables such as the collector dosage (fuel oil), the frother dosages (mibc), the pulp density percent and t...

the growth rate of stem cells in mobius cellready 3l bioreactor has been studied using comsol multi-physics simulation software in order to find out the best operational parameters for secure cell growth. the bioreactor geometry was defined according to the emd millipore issued information while turbulent and unsteady state solid-liquid 2-phase fluid flow equations were used for modelling the b...

Experimental work was carried out to investigate the influence of impeller speed, granulation time, binder mass and their interactions on granule size distribution, mean size and binder content distribution in a conical high shear granulator. It was observed that the response of high shear granulation to changes in process parameters varies significantly from one operating condition to anot...

Impeller trimming is a proper way to alter the performance of centrifugal pump with a constant speed so as to meet the demand on the specified flow rate and head in pumping systems. The affinity law accounting for the impeller trimming is the key relation to determine the pump performance with a trimmed impeller. There seems no experimental study dealing with such an affinity law for centrifuga...

Pressure fluctuation may cause high amplitude of vibration of double‐suction centrifugal pumps, but the impact of impeller stagger angles is still not well understood. In this paper, pressure fluctuation experiments are carried out for five impeller configurations with different stagger angles by using the same test rig system. Results show that the stagger angles exert negligible effects on th...

The paper has established sixteen design schemes for super-low specific speed centrifugal pump compound impeller with orthogonal method, based on the main factors impacting the design of compound impeller, like short blades number of compound impeller, the relative position of blade radial inlet, blade circumferential bias degree, deflection angle, etc.,. By numerical simulation, the optimal de...

Engkabang Fat Esters are produced from the alcoholysis reaction of oleyl alcohol and its fat using enzyme as biocatalyst. The work has been previously carried out mainly on the optimization of Engkabang Fat esters production in organic solvents. However, the effect of impeller speed-substrate molar ratio has yet to be discussed in detail. In the present paper, the influences of impeller speed a...

This paper presents the preliminary steps required for conducting experiments to obtain the optimal operating conditions of a hybrid impeller mixer and to determine the residence time distribution (RTD) using computational fluid dynamics (CFD). In this paper, impeller speed and clearance parameters are examined. The hybrid impeller mixer consists of a single Rushton turbine mounted above a sing...

The effect of impeller speed on the air flow in a selfaerated Denver laboratory flotation cell was investigated using computational modelling. Air is induced into the slurry by the impeller’s rotating action. The rate of air flow is determined by the suction pressure created by the impeller, the hydrostatic head of the slurry and the frictional losses along the delivery shaft from the inlet val...