This paper presents a compact two-stage ultrawideband low-noise amplifier (LNA). A common-gate topology is adopted for the input stage to achieve wideband input matching, while a cascode stage is used as the second stage to provide power gain at high frequencies. A low power consumption and a small chip area are obtained by optimizing the performance of the LNA with tight constraint on biasing ...

This paper presents an improved linearity variable-gain amplifier (VGA) in 0.18-µm CMOS technology. The lineari­ty improvement is resulted from employing a new combinational technique, which utilizes third-order-intermodulation (IM3) cancellation mechanism using second-order-intermodul­ation (­IM2) injection, and intermodulation distortion (IMD) sinking techniques. The proposed VGA gain cell co...

Two-tone intermodulation in ultrahigh vacuum/chemical vapor deposition SiGe heterojunction bipolar transistors (HBTs) were analyzed using a Volterra-series-based approach that completely distinguishes individual nonlinearities. Avalanche multiplication and collector–base (CB) capacitance were shown to be the dominant nonlinearities in a single-stage common-emitter amplifier. At a given , an opt...

This paper describes a baseband analog (BBA) chain for wireless local area network (WLAN) applications. For the given specifications of the receiver BBA chain, the optimum allocation of the gain and filter rejection of each block in a BBA chain is achieved to maximize the SFDR. The fully integrated BBA chain is fabricated in 0.13 μm CMOS technology. An input-referred third-order intercept point...

A 2.4 GHz CMOS up-conversion mixer using novel current mirrors based on chartered 0.18 μm RF CMOS technology for 2.4 GHz wireless sensor network (WSN) application is presented in this paper. The current-reuse current-mirror and current-bleeding technique are used in the driver and switching stages of the mixer, respectively. The post-layout simulation results demonstrate that the novel up-conve...

This paper reports on a fully-integrated CMOS switchable directconversion receiver for 2GHz and 5GHz. Switchable low noise amplifier is proposed for suiting for multiband (2GHz, 5GHz). Sub-harmonic mixing is used for down-conversion to minimize the DC-offset due to LO-leakage. The residual DC-offset is cancelled by a digital-to-analog converter at the output of mixer. For quadrature down-conver...

This journal presents an ultra-low-voltage current bleeding mixer with high LO-RF port-to-port isolation, implemented on 0.13 μm standard CMOS technology for ZigBee application. The architecture compliments a modified current bleeding topology, consisting of NMOS-based current bleeding transistor, PMOS-based switching stage, and integrated inductors achieving low-voltage operation and high LO-R...

This brief presents the design of an improved linear Gilbert mixer with high conversion gain and low noise figure by using multiple gated transistor (MGTR) and switched biasing technique. This mixer operates at a radio frequency (RF) of 2.4GHz with a local oscillator (LO) power of 5dBm in UMC 180nm process. The MGTR method is used to increase the linearity of the proposed mixer by the parallel ...

This paper presents a low voltage wideband downconversion mixer using current-mode approach for multi-standard receivers. The proposed mixer uses a current mirror amplifier with an embedded passive switching core to achieve mixing function, which can combine the advantages of active and passive mixers simultaneously. The mixer is implemented using a 0.18μm CMOS technology and covers frequency b...

This paper presents the design and analysis of Ultra Wideband (UWB) mixer in 65nm CMOS technology. To achieve the optimized performance, a new mixer topology is suggested. The performance parameters of the mixer viz.: conversion gain, Noise Figure, linearity and power consumption are addressed in this paper. The simulation results of the new mixer topology suggested in this paper achieves the r...