A direct downconversion receiver implemented in 0.13 μm 1P8M process is presented. The circuit is formed by a single-end LNA, an active balun for conversion into balanced mode, a quadrature double-balanced passive switch mixer and a quadrature voltage-controlled oscillator. The receiver operates in the 2.4 GHz ISM band and complies with IEEE 802.15.4 (ZigBee) specifications. The circuit exhibit...

In this paper, we proposed a novel bonding technology to fabricate a microfluidic device based on Poly(methyl methacrylate) (PMMA). The method, which used chloroform and ethanol as miscible bonding solvent, can complete complex structures rapid assembly (10 min) at 40°C. A bonding strength of 267.5 N/cm2 can be achieved, while the micro channel deformation was less than 7.26%. Then we utilized ...

The degree of mixing of a T-shaped micro-mixer depends strongly on the inlet flow conditions. Specifically, through a series of numerical simulations, we compared the case where the flow at the micro-mixer confluence is fully developed with that when it is not, and found that in the former case engulfment occurs at smaller Reynolds number, with a different flow pattern and with much larger mixi...

This article presents an agile passive-mixer-first superheterodyne RF front-end that utilizes a gigahertz acoustic filter as its intermediate-frequency (IF) load-essentially mixer-first acoustic-filtering front-end. The passive mixer frequency-translates sharp but fixed-frequency response to much higher and mixer-clock-defined tunable frequency while preserves input matching, high linearity, in...

The mixing of Newtonian and non-Newtonian fluids in a magnetic micro-mixer was studied numerically using  ferrofluid. The mixing process was performed in a three-dimensional steady-state micro-mixer. A magnetic source was mounted at the entrance of the micro-channel to oscillate the magnetic particles. The effects of electric current, inlet velocity, size of magnetic particles, and non-Newtonia...

Owing to the enhancement of surface effects at the micro-scale, patterned grooves on a micro-channel floor remain a powerful method to induce helical flows within a pressure driven system. Although there have been a number of numerical studies on geometrical effects concerning fluid mixing within the staggered herringbone mixer, all have focused mainly on the groove angle and depth, two factors...

Zero-IF receiver has some advantages, such as small factor, low cost and easily integrated on a chip. They make it competitive of RF receivers. However, DC Offset and flicker noise, etc., have profound effects in zero-IF receiver, which need not be considered in super-heterodyne receiver. Following a major study of flicker noise, possible solutions are given, especially those based on the passi...

We give an unified formulation for deterministic and stochastic global optimization algorithms via initial and boundary value problems for different first and second order dynamic systems. The ensemble is applied to the design of a fast-micro-mixer. The aim is to optimize a given mixer shape in order to reduce its mixing time. The algorithms are compared from their complexity and optimization e...

In this paper the influence of two different sizes of silica particles (micro-silica and nano-silica) was studied on mechanical properties of sulfur and sulfur composite. To improve the structural properties, sulfur was plasticized using dicyclopentadiene (DCPD) and methyl styrene (MSt). Plasticized sulfur composite was prepared by melt blending of plasticized sulfur and silica particles. T...

An electrospray microchip for mass spectrometry comprising an integrated passive mixer to carry out on-chip chemical derivatizations is described. The microchip fabricated using UV-photoablation is composed of two microchannels linked together by a liquid junction. Downstream of this liquid junction, a mixing unit made of parallel oblique grooves is integrated to the microchannel in order to cr...