In this paper, a new shape memory alloy (SMA) hybrid basalt fibre reinforced polymer (BFRP) composite laminate was fabricated and a new surface modification method with both silane coupling agent KH550 and Al₂O₃ nanoparticles was conducted to enhance the interface performance. The mechanical performance of BFRP composite laminates with and without SMA fibres and the influence of SMA surface mod...

The extraordinary properties of graphene and carbon nanotubes motivate the development of methods for their use in producing continuous, strong, tough fibres. Previous work has shown that the toughness of the carbon nanotube-reinforced polymer fibres exceeds that of previously known materials. Here we show that further increased toughness results from combining carbon nanotubes and reduced grap...

Electrospinning has been used for decades to generate nano-fibres via an electrically charged jet of polymer solution. This process is established on a spinning technique, using electrostatic forces to produce fine fibres from polymer solutions. Amongst, the electrospinning of available biopolymers (silk, cellulose, collagen, gelatine and hyaluronic acid), chitosan (CH) has shown a favourable o...

From consideration of the extent of contact between fibres in electrospun polymer networks, we provide theory relating the specific surface area of the network to the characteristic dimensions of interfibre voids. We show that these properties are strongly influenced by the cross-sectional morphologies of fibres. Whereas porosity has a strong influence on pore dimensions, in the range of porosi...

Researches in the field of conductive polymers have attracted considerable attention for more then 20 years. Among the conductive polymers, polyaniline and polypyrrole have drawn considerable interest because of their economical importance, good environmental stability and satisfactory electrical conductivity when doped. On the other hand, electrically conductive materials such as aluminium pow...

A new method for the preparation of gas separation membranes in a one-step procedure is presented, where common, non-volatile solvents can be used in the polymer solution. It concerns contacting of a polymer solution with two successive nonsolvent baths, whereby the first bath initiates the formation of a dense top layer and the second bath gives the actual polymer precipitation. Membranes made...

Submitted: Jul 2, 2013; Accepted: Aug 18, 2013; Published: Aug 29, 2013 Abstract: Experimental Studies were conducted to analyse the influence of crimped polypropylene fibres in cementitious matrix. The compressive strength of concrete with the addition crimped polypropylene fibres for relative volume fractions of 0.1% and 0.3% were evaluated in concrete with water cement ratio as low as 0.3. H...

Using freely jointed polymer model we compare equilibrium properties of crowded polymer chains whose segments are either permeable or not permeable for other segments to pass through. In particular, we addressed the question whether non-permeability of long chain molecules, in the absence of excluded volume effect, is sufficient to compartmentalize highly crowded polymer chains, similarly to wh...

Bragg gratings in etched polymer fibres and their unique properties and characteristics are discussed in this paper. Due to the change in material and mechanical properties of the polymer fibre through etching, Bragg gratings inscribed in such fibres show high reflectivity and enhanced intrinsic sensitivity towards strain, temperature, and pressure. The short-term and long-term stability of the...