The quest for efficient and scalable parallel reservoir simulators has been evolving with the advancement of high performance computing architectures. Among the various challenges of efficiency and scalability, load imbalance is a major obstacle that has not been fully addressed and solved. The reasons that cause load imbalance in parallel reservoir simulation are both static and dynamic. Robus...

Reservoir simulation models are used extensively to model complex physics associated with fluid flow in porous media. Such models are usually large with high computational cost. The size and computational footprint of these models make it impractical to perform comprehensive studies which involve thousands of simulation runs. Uncertainty analysis associated with the geological model and field d...

The significant increase in using reservoir simulation models poses significant challenges in the design and calibration of models. Moreover, conventional model calibration, history matching, is usually performed using a trial and error process of adjusting model parameters until a satisfactory match is obtained. In addition, history matching is an inverse problem, and hence it may have non-uni...

Fully compositional and thermal reservoir simulation capabilities are important in oil exploration and production. There are significant resources in existing wells and in heavy oil, oil sands, and deep-water reservoirs. This article has two main goals: (1) to clearly identify chemical engineering sub-problems within reservoir simulation that the PSE community can potentially make contributions...

constructing phase diagram and its subsequent quality lines for lean gas condensate reservoirs is always crucial and challenging topic in reservoir fluid studies. due to small amounts of liquid drop-outs in lean gas condensates at reservoir conditions, full experimental tracking of phase diagram and its relevant quality lines is almost impossible for lean gas condensates.on the other hand, eos ...

We consider optimization of computational grids for petroleum reservoir flow simulations. In this context grid quality is determined by two independent error sources. On the one hand there is a loss of precision caused by upscaling of geological data from the fine geological grid to the coarser computational grid, and on the other hand there are numerical errors induced by a non-regular computa...

the karkheh dam reservoir with a capacity of more than 5 billion cubic meter is the largest dam in iran with both agricultural and drinking usages. its hydrodynamics and water quality were modeled and simulated to analyze the total maximum daily load (tmdl) of total dissolved solids (tds). the simulation was supported with measurements of temperature and tds measurements during two years. a lat...

Petroleum resources are found within sedimentary rocks that have a sufficient interconnected void space to store and transmit fluids. The actual flow of liquid and gas phases occurs on a micrometer scale in the void space between rock grains. On the other hand, the hydrocarbon is typically carried in rock zones that are a few tens of meters thick but extend several kilometers in the lateral dir...