SiC powder preparation using Sol-Gel method. The size of nano-particles grows as the temperature exceeds 900° C. Size of probable agglomerations produced, is approximately less than 50nm. The surface is suitable to be used for dye solar cells. SiC emission occurs at wavelength area of 11.3μm or wave number area of 884.95 cm-1. In this paper probing the nature of annealed SiC samples in mixture,...

This work studies the use of gold (Au) and silver (Ag) nanoparticles in multicrystalline silicon (mc-Si) and copper-indium-gallium-diselenide (CIGS) solar cells. Au and Ag nanoparticles are deposited by spin-coating method, which is a simple and low cost process. The random distribution of nanoparticles by spin coating broadens the resonance wavelength of the transmittance. This broadening favo...

Amorphous carbon (a-C) thin films have been synthesized by microwave (MW) surface wave plasma (SWP) chemical vapor deposition (CVD) on n-type silicon and quartz substrates, aiming at the application of the films for photovoltaic solar cells. Argon, acetylene and trimethylboron were used as a carrier, source and dopant gases. Analytical methods such as X-ray photoelectron spectroscopy (XPS), Hal...

For analyzing the long-term behavior of thin film a-Si/μc-Si photovoltaic modules, it is important to observe the light-induced degradation (LID) in dependence of the temperature for the parameters of the one-diode model for solar cells. According to the IEC 61646 standard, the impact of LID on module parameters of these thin film cells is determined at a constant temperature of 50°C with an ir...

A solar cell is an electronic device which not only harvests photovoltaic effect but also transforms light energy into electricity. In photovoltaic phenomenon, a P-N junction is created to form an empty region.  The presented paper aims at proposing a new highly efficient InGaN/Si double-junction solar cell structure. This cell is designed to be used in a real environmental situation, so only s...

This chapter presents the main stream technology of c-Si solar cells. It explores development in design and technology of the c-Si solar cells from traditional to advanced device architecture. It highlights the historical development in cell design and technology along with the technological approach which are being researched for next generation c-Si solar cells. Starting from most general cel...

This chapter presents the main stream technology of c-Si solar cells. It explores development in design and technology of the c-Si solar cells from traditional to advanced device architecture. It highlights the historical development in cell design and technology along with the technological approach which are being researched for next generation c-Si solar cells. Starting from most general cel...

Directionally solidified multicrystalline silicon (mc-Si)-based solar cells have dominated the global photovoltaic market in recent years. The photovoltaic performance of mc-Si solar cells is strongly influenced by their crystalline defects. The occurrence of minicrystallization results in much smaller grain size and, therefore, a larger number of grain boundaries in mc-Si ingots. Dislocations ...

In this article, we report on the use of transmission electron microscopy (TEM) for the fabrication of high-performance textured amorphous/crystalline silicon (a-Si:H/c-Si) heterojunction (HJ) solar cells. Whereas classical thin-film characterization techniques allowed us to optimize the a-Si:H layer properties for flat HJ solar cells (open-circuit voltages (VOC) up to 710 mV and energy convers...

Surface plasmons, which exist along the interface of a metal and a dielectric, have been proposed as an efficient alternative method for light trapping in solar cells during the past ten years. With unique properties such as superior light scattering, optical trapping, guide mode coupling, near field concentration, and hot-electron generation, metallic nanoparticles or nanostructures can be tai...