Air film cooling has been widely employed to cool gas turbine hot components such as combustor liners, combustor transition pieces, turbine vanes and blades. Enhancing air film cooling by injecting mist with tiny water droplets with diameters of 5-10μm has been studied in the past on flat surfaces. This paper focuses on computationally investigating the curvature effect on mist/air film cooling...

A new measurement technique for the determination of the heat transfer coefficient and the film cooling effectiveness is presented. It is based on a regression of multiple transient liquid crystals experiments using an electrical heater-foil producing a nonhomogeneous surface heat flux. This is particularly interesting for film-cooled surfaces where each cooling hole in the heater-foil leads to...

We report fabrication of large area Ag nanowire (NW) film coated using a continuous roll-to-roll (RTR) slot die coater as a viable alternative to conventional ITO electrodes for cost-effective and large-area flexible touch screen panels (TSPs). By controlling the flow rate of shear-thinning Ag NW ink in the slot die, we fabricated Ag NW percolating network films with different sheet resistances...

Experiments were performed to investigate the two-phase cooling characteristics of a new hybrid cooling scheme combining the cooling attributes of slot jets and micro-channel flow. A test module was constructed in which dielectric PF-5052 liquid was introduced through five 0.48 mm wide and 12.7 mm long slot jets, each leading to a 1.59 mm wide and 1.02 mm deep channel. Increases in flow rate an...

Film cooling is a cooling technique widely used in highperformance gas turbines to protect the turbine airfoils from being damaged by hot flue gases. Motivated by the need to further improve film cooling in terms of both cooling effectiveness and coolant coverage area, the mist/air film cooling scheme is investigated through experiments in this study. A small amount of tiny water droplets (7% w...

An experimental investigation was conducted to study the performance of film cooling injection from a cylindrical hole and a “W-shaped” hole. A Pressure Sensitive Paint (PSP) technique was used to map the spatial distribution of film cooling effectiveness on the surface of the test plate based on a mass-transfer analogy. The effects of mass flux ratio and density ratio on film cooling effective...

This paper presents a numerical study to investigate the feasibility of transporting mist through the internal cooling channel in high-pressure turbine vanes for film cooling over the vane's surface. The idea of using mist film cooling to enhance conventional air cooling has been proven to be a feasible technique in the laboratory conditions and by computational simulations. However, there is a...

Film cooling technique has been successfully applied to gas turbine blades to prevent it from the hot flue gas. However, a continuous demand of increasing the turbine inlet temperature to raise the efficiency of the turbine requires continuous improvement in film cooling effectiveness. The concept of injecting mist (tiny water droplets) into the cooling fluid has been proven under laboratory co...