Acase studywas conducted to investigate the seismic behavior of steel plate shear walls having boundary elements designed by two different philosophies. The first design approach does not guarantee that formation of in-span plastic hinges on horizontal boundary elements (HBEs) will be prevented, whereas the second approach guarantees that plastic hinges can only occur at the ends of HBEs. Pusho...

In order to quantitatively evaluate the shear-bearing capacity of shear connectors of square concrete filled steel tube (CFST), push-out tests on 14 square CFSTs with shear connectors have been carried out. Among the 14 CFSTs, there are 13 specimens with steel plate connectors and one specimen with steel bar connectors. The following factors are investigated to figure out their influences on th...

This paper describes the prototype design, specimen design, experimental set-up, and experimental results of tests on three light-gauge steel plate shear wall (SPSW) concepts. Prototype light-gauge steel plate shear walls are designed as seismic retrofits for a hospital structure in an area of high seismicity and emphasis is placed on minimizing their impact on the existing framing. Three singl...

damages due to northridge and kobe earthquakes were expressive of considerable effects of vertical components of earthquakes compared to the horizontal ones. on the other hand, thin steel plate shear wall is one of the newest resistant systems which until now it`s behavior haven’t been investigated under vertical component of earthquake. therefore, in this article, effects of vertical component...

Steel plate shear walls (SPSWs) are one of the most economical and under-utilized lateral load resisting systems currently available to structural engineers. In comparison with traditional lateral load systems, such as steel braced frames, reinforced concrete walls and moment resisting frames, SPSWs have fewer costly detailing requirements, require less stringent construction tolerances, allow ...

The AISC Seismic Provisions and CSA S-16 Standard require a minimum moment of inertia for the vertical boundary elements (VBEs) in steel plate shear walls (SPSWs) to avoid undesirable VBE behaviors. The equation limiting VBE flexibility has been derived from a flexibility factor, ωt, developed in plate girder theory and the limit on VBE flexibility has been empirically specified based on previo...

This paper presents some preliminary results of an ongoing research whose objective is to investigate the seismic behavior of intermediate beams (i.e., the beams other than those at the roof and foundation levels) in multi-story steel plate shear walls (SPSWs). Of primary interest is the determination of the strength level needed to avoid the formation of in-span plastic hinges, a relevant prac...

Lightweight steel framing is a method in housing and construction that have been widely used in lightweight steel construction. In this method, the structure is built by cold formed steel elements. They are cost-effective, light, and easy to assemble. However, the performance of lateral load resisting systems in cold-formed steel structures specially the behavior of cold-formed steel shear wall...